PART NO. 37-6316A
0145
Printed in U.S.A.
PRECAUTIONS
DESCRIPTION
This adaptor plate assembly is designed for mounting a
Comfort-Set 80 series thermostat to the wall or to a
junction box. The wall cover plate covers the junction box,
wall damage, or old thermostat markings. The adaptor
plate is designed to allow horizontal thermostat mounting,
regardless of junction box orientation.
All kits may not have adaptor plate or all screws shown.
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
CONTENTS
Description ........................................................ 1
Precautions ....................................................... 1
Installation ......................................................... 2
INSTALLATION INSTRUCTIONS
Operator: Save these instructions for future use!
F61 Series
Adaptor Plate Assembly
To prevent electrical shock and/or equip-
ment damage, disconnect electrical power
at main fuse or circuit breaker until installa-
tion is complete.
This instruction sheet is not intended as a wiring guide.
Refer to the thermostat installation instructions to ensure
proper wiring.
NOTE
CAUTION
!
WHITE-RODGERS
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
www.white-rodgers.com
Adaptor Plate
No. 6 X
5
/
16
” Phillips
pan-head screw (2)
6-32 X
3
/
4
” flat-head
machine screw (4)
F61-2500
Wall Plate
2
Junction Box
Adaptor Plate
Locate and drill two
clearance holes in wall
6-32 X
3
/
4
” flat-head
machine screws
1F8X
Thermostat
Subbase
F61-2500
Wall Plate
Figure 2. Mounting 1F8X digital thermostat to vertical junction box
6-32 X
3
/
4
” flat-head
machine screws
No. 6 X
5
/
16
” Phillips
pan-head screw (2)
INSTALLATION
FOR 1F8X DIGITAL THERMOSTATS
1F8X
Thermostat
Subbase
F61-2500
Wall Plate
Junction Box
6-32 X
3
/
4
” flat-head
machine screws
Figure 1. Mounting 1F8X digital thermostat to horizontal junction box
No. 6 X
5
/
16
” Phillips
pan-head screw (2)
3
1F8X
Thermostat
Subbase
F61-2500
Wall Plate
Wall
Figure 3. Mounting 1F8X digital thermostat to wall
No. 6 X
5
/
16
” Phillips
pan-head screw (2)
No. 6 X 1” pan-head screws
(supplied with thermostat)
NOTE
When installing wall cover plate and thermostat directly to
wall, use the pointed screws supplied with the thermostat.
If you need further information about this product, please write to
White-Rodgers
Emerson Electric Co.
St. Louis, MO 63123-5398
Attention: Technical Service Department
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
White Rodgers 37-5148B User manual
-
-
-
-
-
-
-
White Rodgers 903990 User manual
-
-