Chief Kontour Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
This manual is also suitable for
Chief Kontour is a versatile desk mount solution that offers a wide range of motion and adjustability for your monitor or TV. With its sleek design and sturdy construction, it's the perfect choice for creating an ergonomic and comfortable viewing experience.
Chief Kontour is a versatile desk mount solution that offers a wide range of motion and adjustability for your monitor or TV. With its sleek design and sturdy construction, it's the perfect choice for creating an ergonomic and comfortable viewing experience.
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Grommet Mounting Kit
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
KRA204
KRA204 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! The KRA204 can ONLY be mounted
onto desks measuring between 3/4" and 4" in depth!
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
DESKTOP THICKNESS
RANGE .75- 4.0" [19.1 - 101.6]
DESK SURFACE
COLUMN FROM MOUNT
SHOWN FOR CLARITY ONLY
(NOT INCLUDED)
Installation Instructions KRA204
3
TOOLS / PARTS FOR INSTALLATION
ASSEMBLY AND INSTALLATION
1. Remove desk clamp from mount by removing four flat head
cap screws until clamp is disconnected from column. (See
Figure 1)
NOTE: Lower portion of clamp may need to be lowered or
removed in order to gain access to these screws.
Figure 1
2. Use four screws removed in Step 1 to column plate (A) to
column. (See Figure 2)
3. Affix five rubber feet (D) to column plate (A). (See Figure 2)
Figure 2
4. Locate a flat surface (thickness of 3/4" minimum to 4"
maximum) on which to mount the column plate.
5. If mounting hole does not already exist on desk, drill
mounting hole in desk at desired mounting location.
IMPORTANT ! : Mounting hole must be a minimum of
5/16" in diameter and a maximum of 2"!
6. Position mount on desk so that center hole of column plate
(A) is centered over grommet hole. (See Figure 3)
7. Insert 5/16-18 x 5" bolt (C) through grommet bracket (B),
grommet hole and thread into center hole on underside of
column plate (A). (See Figure 3)
Figure 3
8. Tighten 5/16-18 x 5" bolt (C) until grommet bracket (B) is
tightened against underside of desk and column mount is
securely mounted to desk. (See Figure 3)
9. Complete the installation following the mount installation
instructions.
1/2"
(if hole needs to be created)
1/8"
A (1)
[column plate]
B (1)
[grommet bracket]
C (1)
5/16-18 x 5"
D (5)
[rubber feet]
E (1)
1/8"
1
x 4
2
x 4
(A)
3
(D) x 4
(A)
8
(C)
6
7
(B)
KRA204 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002073 Rev01
2011 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
10/11
-
1
-
2
-
3
-
4
Chief Kontour Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
- This manual is also suitable for
Chief Kontour is a versatile desk mount solution that offers a wide range of motion and adjustability for your monitor or TV. With its sleek design and sturdy construction, it's the perfect choice for creating an ergonomic and comfortable viewing experience.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Chief K4G310B Operating instructions
-
Chief K4G120 User manual
-
Chief K1P100S Installation guide
-
-
Chief K2C220SXF1 Installation guide
-
-
Chief K1C110B Installation guide
-
Chief K4G320B Operating instructions
-
Vizio K3-F-Series Operating instructions
-