Keating Pre 2000 User manual

JUL-96

INSTALLATION INSTRUCTIONS FOR

CENTRAL MOTOR RESET MECHANISM (pre 2000 series)

1. Looking from front of unit, loosen the two bolts on the right side of motor mount.

2. Align slots on reset mechanism mounting bracket with loosened bolts and slide

mounting bracket under bolt heads but on top of base plate of motor.

3. Push reset mechanism guide block tight against motor base plate and retighten bolts

while holding in place.

4. Pull rod to check alignment with motor reset button.

SECTION A-A

1. LOOSEN BOLTS

REAR VIEW

FRONT VIEW

TOP VIEW

FILTER MOTOR REF.

2. SLIDE BRACKET

OVER MOTOR BASE &

UNDER BOLT HEADS.

3. HOLD GUIDE BLOCK

TIGHT AGAINST

MOTOR BASE WHILE

TIGHTENING BOLTS.

4. CHECK ALIGNMENT

FILTER MOTOR RESET

PULL HANDLE

MOTOR RESET MECHANISM

ASSEMBLY #023798

LABEL #024117

“FILTER MOTOR RESET

PULL HANDLE”

FILTER

PUMP

PULL ROD

RESET MECHANISM

SERVICE INSTRUCTIONS

www.keatingofchicago.com 1-800-KEATING