Energizer 8970592 Owner's manual

Type
Owner's manual

This manual is also suitable for

No.
Description
Qty
No.
Description
Qty
1 Booster cable 1 6&7 Screw-in-crew Side
Terminal Bolt
2
2 Cap 1
3 Bolt(M) 2 8 Copper Spacer 2
4 Nut(M) 2 9 Bolt(S) 2
5 Aluminum Spacer 2 10 Nut(S) 2 1
5
4
4
5
3
3
INSTALLATION INSTRUCTIONS FOR PLUG-IN BOOSTER CABLES
For Top Mount Batteries
(ALL HARDWARE INCLUDED)
1. Remove bolts from service vehicle battery and
discard. Use new bolts included with the Booster
Cables.
2. Attach new Bolt(3), Spacer(5) and
Nut(4) for both pos. “+” and neg. “-” battery
terminal hook-ups as shown. Be careful to
attach the positive cable (the cable with the red
stripe on the terminal end) to the positive post on
the battery, as well as the negative cable to the
negative post.
For Side Mount Batteries
(ALL HARDWARE INCLUDED)
1. Remove bolts from service vehicle battery and
discard. Use new Bolt(6), Spacer(8) and
Nut(7) included with the Booster Cables.
2. Attach the battery cables with the new Bolts(6)
(one “screw-in-screw” side terminal bolt for each
terminal hook-up).
3. Attach booster cables to terminal bolt as shown
right. Be careful to attach the positive cable (the cable
with the red stripe on the terminal end) to the positive
post on the battery, as well as the negative cable to the
negative post.
PARTS LIST:
DISCARD
NEG
POS
TO
GROUND
NEG
TO
STARTER
POS
SCREW-IN-SCREW
SIDE TERMINAL
BOLT
EXISTING CABLES
PERMANENT
PLUG-IN BOOSTER CABLE
2 4 5 6 7 8 10
3
9
6
87
6
87
Bolt(9) and Nut(10) are used for attaching the Plug-in Connector to the vehicle. Cap(2) is used for
protecting the Plug-in Connector from water and dust during storage.
  • Page 1 1

Energizer 8970592 Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI