2. Valor
  3. 556CLA

Valor 556CLA Owner's manual

  • Hello! I have reviewed the product details of the Valor 530 Direct Vent Heater and the 556 CLA Co-Linear Adapter. I understand that this kit is for converting solid co-axial piping to flexible co-linear piping for installation into existing solid fuel fireplaces. The document specifies that the 556 CLA adapter can be fitted to the top or rear outlet, and that the system requires the use of Simpson Dura-Vent components for proper vertical termination. I'm ready to answer your questions about this product.
  • Can co-linear piping be used in combustible fireplace cavities?
    What additional components are required to complete the co-linear chimney system?
    Is this kit usable for sidewall termination?
Phone 1 – 800 – GO – VALOR
www.valorflame.com
556 CLA Kit
Model 530 Direct Vent
Installed as an Insert
Using Model 556 Co-Linear Adapter
April ‘04
General
The 556 CLA Co-Linear adapter is a field installed kit to convert listed direct vent
heaters from solid co-axial piping to flexible 3”, side by side, co-linear piping for
installation into existing solid fuel fireplaces and chimneys. Co-linear piping can not
be used in combustible fireplace and chimney cavities. The 556 CLA may be fitted to
the Top or Rear outlet of the 530 heater. This kit is for vertical termination only –
not sidewall.
A Simpson Dura-Vent 923GK and either a 980 or 991 Terminal cap are
required to complete the termination of the co-linear chimney system.
Note : Venting limitations and restrictors are as per those listed for co-axial
venting in the heater installation manual
923 GK Adapter & Flashing
980 Terminal Cap
991 Terminal Cap
With 536 President Front
With 541 Bolero Front
With 539 Windsor Arch & Plate
With 549 Windsor Arch
/