Matsui M17KSS09 User manual

Brand: Matsui

Model: M17KSS09

Category: Electric kettles

Type: User manual

Matsui M17KSS09 is a polished stainless steel kettle with a 1.7L capacity. It has a power consumption of 2000-2200W and is suitable for use with a 230-240V~50Hz mains supply. The kettle has an automatic safety cut-off feature to prevent it from boiling dry. It also has a removable scale filter to prevent loose particles of limescale from being poured into your beverage. The kettle is easy to clean and maintain, and it comes with a one-year warranty.

• Read all the instructions carefully before using this appliance and keep them for

future reference.

• Retain the manual. If you pass the appliance on to a third party, make sure to include

this manual.

• Unplug the appliance from the mains socket when not in use, or before cleaning any

part of the appliance.

• Allow the appliance to cool fully before cleaning.

• Never immerse the appliance in water and always keep the electrical contacts dry.

• Never place the appliance on or near a source of heat such as a cooker ring or gas

ame.

• Always place the appliance on a dry, at and stable surface.

• Avoid contact with the steam from the appliance’s spout. Take care when pouring or

relling after boiling.

• Always make sure the water covers the bottom of the appliance to prevent it from

boiling dry.

• Do not use the appliance to heat anything other than water.

• Do not interfere with the normal working of the switch.

• Always keep the appliance out of the reach of small children and never allow the

mains cable to hang over the edge of the work surface. Children should be taught

about the dangers of boiling water.

• This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instructions concerning the use of the

appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• If the mains cable is damaged it must be replaced by the manufacturer, its service

agent, or similarly qualied persons in order to avoid a hazard.

Safety First!

Please follow all the safety precautions listed below for your safety and to reduce the

risk of injury or electrical shock.

Mains supply: 230-240V~50Hz

Power consumption: 2000-2200W

We continually strive to improve our products, specications may change without

prior notice.

Specifications

This symbol on the product or in the instructions means that your

electrical and electronic equipment should be disposed at the end of

its life separately from your household waste. There are separate

collection systems for recycling in the EU.

For more information, please contact the local authority or your

retailer where you purchased the product.

Visit Partmaster.co.uk today for the easiest way to buy electrical spares

and accessories.

With over 1 million spares and accessories available we can deliver direct

to your door the very next day.

Visit www.partmaster.co.uk

Or call

0870 6001 338

(UK customers only)

Calls charged at National Rate.

DSG Retail Ltd. Maylands Avenue Hemel Hempstead

Hertfordshire HP2 7TG England

GB - 1

GB - 5

POLISHED STAINLESS STEEL

KETTLE

INSTRUCTION MANUAL

M17KSS09

Cleaning the removable scale ﬁlter

To prevent loose particles of limescale being

poured into your beverage, your kettle is ﬁtted

with a scale ﬁlter. You may remove the ﬁlter

and ﬁt it back in after cleaning.

To ﬁt in the ﬁlter, insert the ﬁlter into the ﬁlter

holder. Open the lid, place the ﬁlter holder

inside the bracket at the spout, and push it

down till it ﬁts in place.

To remove the ﬁlter, open the lid, lift up the

ﬁlter holder from the bracket at the spout.

Remove the ﬁlter from the ﬁlter holder.

Before using this appliance ensure that the voltage of your electricity supply is

suitable for that indicated on the rating plate of the appliance.

THIS APPLIANCE MUST BE EARTHED.

The ultimate disconnection from the power source is the mains plug. Always make

sure it is easily accessible to be unplugged in the event of an emergency.

This appliance is ﬁtted with a fused three pin mains plug to BS 1363 which will be

suitable for use in all houses ﬁtted with mains sockets to current speciﬁcations.

If the ﬁtted mains plug is not suitable, remove the fuse and dispose of the mains

plug safely, immediately after removing it from the mains cable.

Fitting a new mains plug

If for any reason you need to ﬁt a new mains plug, the mains cable must be

connected as shown here. The wires in the mains cable ﬁtted to this appliance are

coloured in accordance with the following code:

If the colours of the wires in the mains cable of this appliance do not correspond

with the coloured markings identifying the terminals in your mains plug, proceed as

follows:

The wire which is coloured

• Green and Yellow: MUST be connected to the terminal which is marked with the

letter E (Earth) or symbol or coloured Green.

• Blue: MUST be connected to the terminal which is marked with the letter N

(Neutral) or coloured Blue or Black.

• Brown MUST be connected to the terminal which is marked with the letter L (Live)

or coloured Brown or Red.

Before reﬁtting the mains plug cover, check that there are no cut or stray strands of

wire inside the mains plug. Only BSI or ASTA approved 13 Amp BS1362 fuses should

be used. If you are in any way unsure which mains plug or fuse to use, always refer to

a qualiﬁed electrician.

Note: After replacing or changing a fuse on a moulded mains plug which has a fuse

cover, the cover must be reﬁtted to the mains plug, the appliance must not be used

without a fuse cover. If lost, replacement fuse covers can be obtained from an

electrical shop.

GB - 2 GB - 3

GB - 4

Keeping the cord tidy

Extend the mains cable in the kettle stand to the

required length. Locate the mains cable in one of the

slots in the stand. For safety it is recommended that

the length of exposed mains cable is kept as short as

possible. Place the kettle stand on a ﬁrm level surface

and plug in the mains plug at a standard mains

socket (240 Volt 13 Amp rated).

Caution. This kettle must only be used with the

stand provided.

Before using your kettle for the First Time

Clean your kettle by boiling a full kettle of water twice and then discarding the

water.

Filling the kettle

Slide the switch to open the lid and ﬁll the kettle

with the required amount of water. Do not exceed

the maximum ﬁll level (Max 1.7L) as indicated inside

the kettle and not less than the minimum ﬁll level

(Min 0.5L).

Caution. If the kettle is overﬁlled, boiling water

may be ejected from the spout and cause

scalding.

Switching on

Place the kettle on the stand and press the power

switch to the ON position (indicated by the symbol

‘1’). The indicator on the side of the kettle will light

up to indicate that the kettle is heating.

Caution. Never open the lid while the water is

boiling. The steam coming out from the kettle is

very hot.

Caution. If there is insufﬁcient water in the kettle,

the automatic safety cut-off will operate. If this

happens, allow the kettle to cool for ten minutes

before reﬁlling with cold water and re-boiling.

When the water has boiled

The kettle will automatically switch o (indicated by

the symbol ‘0’ ).

Caution. Ensure that the switch is not obstructed

and the lid is ﬁrmly closed. The kettle will not turn

off if the switch is obstructed or if the lid is open.

Caution. After removing the kettle, there may be

some water on the surface of the stand. This is

condensation from the steam that causes the

kettle to automatically switch off after boiling. This

is normal and should not be a cause for alarm.

Cleaning the kettle

The kettle exterior should be cleaned with a soft damp cloth. Do not use abrasive

cleaners or scouring pads which may damage the ﬁnish of the kettle.

Never immerse the kettle or kettle stand in water and always keep the electrical

contacts dry. Disconnect from the mains before cleaning the kettle stand.

Caution. Do not insert any foreign objects or allow any liquid to spill into the Power

Connector Hole.

Electrical Information

CONNECT GREEN AND YELLOW TO EARTH (E)

CONNECT

BLUE TO

NEUTRAL (N)

MAKE SURE THE OUTER

SHEATH OF THE MAINS

CABLE IS SECURELY HELD

BY THE CLAMP

CONNECT

BROWN TO

LIVE (L)

13 AMP FUSE

Power Connector Hole

Descaling the kettle

Depending on the hardness of the water in

your area, limescale may be deposited on the

heating element and the inside of the kettle.

This normal build-up is not harmful to health

but an excessive amount of scale may aect

the performance of the kettle.

To descale, ﬁll the kettle with distilled water

up to three-quarters of the Max level and

bring the water to boil. After the kettle has

switched o, add a descaling solution

following the manufacturers instructions.

Never attempt to descale the kettle by

chipping or scraping with a sharp

implement.

90°

Matsui M17KSS09 User manual

Brand: Matsui

Model: M17KSS09

Category: Electric kettles

Type: User manual

Download PDF

report

Matsui M17KSS09 User manual

Matsui M17KSS09 User manual

Related papers

Other documents