PB42 Belt Clip Instructions
The PB42 belt clip (P/N 074964) makes it easy for you to attach
the PB42 printer to your belt. The belt clip kit contains this
instruction sheet and these parts:
• Belt clip
• Belt clip base
• Torx screws (2)
To install the belt clip
1 Attach the belt clip base to the back of the PB42 with the two
Torx screws.
Belt clip
base
Screw
(2 places)
2 Attach the belt clip to your belt.
Belt clip
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2005 Intermec Technologies
Corporation. All rights reserved.
PB42 Belt Clip Instructions
*943-047-001*
P/N 943-047-001
3 Rotate the printer 90° to align the opening in the belt clip base
with the tab on the belt clip.
4 Insert the printer into the belt clip and let it rotate back to its
natural vertical position.
-
1
-
2
Intermec 74964 Supplementary Manual
- Type
- Supplementary Manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Intermec PB42 User manual
-
-
-
-
-
-
-
-
-