Explore Scientific Radio-controlled alarm clock Owner's manual

EN

INSTRUCTION MANUAL ...............2

IT

ISTRUZIONI PER L’USO .............. 14

DE

BEDIENUNGSANLEITUNG .......... 28

FR

MODE D‘EMPLOI ....................... 42

ES

MANUAL DE INSTRUCCIONES .... 56

*Radio-controlled clock function not available in all territories. / Funzione di orologio radiocontrollati non disponibile in ogni territorio. / Funkuhrfunktion nicht in jederm Gebiet verfügbar. / La fonction

d‘horloge radio-piloté n‘est pas disponible dans tous les territoires. / La función de reloj radiocontrolado no está disponible en todos los territorios.

RADIO-CONTROLLED* ALARM CLOCK

SVEGLIA RADIOCONTROLLATA*

FUNKWECKER*

RÉVEIL RADIO-COMMANDÉ*

DESPERTADOR RADIO-CONTROLADO*

Art.No.: RDC3006

2

ABOUT THIS INSTRUCTION

MANUAL

These operating instructions are to be

considered a component of the device.

Please read the safety instructions and the

operating instructions carefully before use.

Keep these instructions for renewed use at a

later date. When the device is sold or given to

someone else, the instruction manual must be

provided to the new owner/user of the product.

The device is intended only for indoor use.

GENERAL WARNINGS

• Risk of electric shock — This device

contains electronic components that oper-

ate via a power source (power supply and/

or batteries). Children should only use the

device under adult supervision. Only use

the device as described in the manual;

otherwise, you run the risk of an electric

shock.

• Choking hazard — Children should only

use the device under adult supervision.

Keep packaging material, like plastic bags

and rubber bands, out of the reach of chil-

dren, as these materials pose a choking

hazard.

• Risk of chemical burn — Keep batteries

out of the reach of children! Make sure you

insert the batteries correctly. Leaking bat-

tery acid can lead to chemical burns. Avoid

contact of battery acid with skin, eyes and

mucous membranes. In the event of con-

tact, rinse the affected region immediately

with a plenty of water and seek medical

attention.

• Risk of re/explosion — Do not expose the

device to high temperatures. Use only the

recommended batteries. Do not short-cir-

cuit the device or batteries, or throw them

3

EN

IT

DE

FR

ES

into a re. Excessive heat or improper han-

dling could trigger a short-circuit, a re, or

an explosion.

• Do not disassemble the device. In the

event of a defect, please contact your

dealer. The dealer will contact the Service

Centre and can send the device in to be

repaired, if necessary.

• Use only the recommended batteries. Al-

ways replace weak or empty batteries with

a new, complete set of batteries at full ca-

pacity. Do not use batteries from different

brands or with different capacities. The

batteries should be removed from the unit

if it has not been used for a long time.

SCOPE OF DELIVERY

Alarm clock, Operating instructions, 2x AAA

batteries.

BEFORE YOU BEGIN

• We recommend using alkaline batteries.

If temperatures regularly fall below 0°C

(32°F), we recommend using lithium batter-

ies.

• Avoid using rechargeable batteries. (Re-

chargeable batteries cannot maintain cor-

rect power requirements.)

• Insert batteries before rst use, matching

the polarity in the battery compartment. 2x

AAA Batteries are required.

4

PRODUCT OVERVIEW

1.

Press [ ] to activate the

snooze function and backlight for 8

seconds. The Snooze function will

stop the alarm for 8 minutes.

2. Press [ ] to turn on/off alarm.

3. Press [ ] to toggle between the

calendar and alarm display. Press and

hold to enter the alarm setting mode.

4. Press and hold [ ] to enter time

and date setting mode.

5. Press and hold [ ] to turn RCC on/off.

In setting mode, press to increase one

unit, press and hold to increase rap-

idly.

6. In setting mode, press [ ] to decrease

one unit, press and hold to decrease

rapidly.

   



5

EN

IT

DE

FR

ES

7. Press the RESET button to restore set-

tings to factory default.

8. Battery compartment. Slide down to

open.





6

BUTTON

MODE

Standard

mode

PRESS

Turn on backlight

for 8 seconds

(SNOOZE when

alarm is ringing)

Turn Alarm

on/off

Stop alarm

(ringing)

Toggle between

Calendar and

Alarm display

_______ _______ _______

HOLD _______ _______

Enter into

alarm setting

Enter into

time and

date setting

Turn RCC

on/off

_______

Time

setting

mode

PRESS

_______ _______

Conrm

setting

Conrm

setting

Increase Decrease

HOLD

_______ _______ _______ _______

Quick

Increase

Quick

Decrease

Alarm

setting

mode

PRESS

_______ _______ _______

Conrm

setting

Increase Decrease

HOLD

_______ _______ _______ _______

Quick

Increase

Quick

Decrease

7

EN

IT

DE

FR

ES



LCD DISPLAY

1.

Time display

2. Calendar display

3. Weekday display

4. Temperature display

[

] RCC signal received

[

] Time Zone indicator

[

] Snooze activated

[

] Alarm 1 ON

[

] Alarm 2 ON

[ ] Alarm 1 + Alarm 2 ON

[

] Low battery indicator

  

8

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.

2. Insert 2x AAA (LR03)/1.5V batteries. Please

ensure the polarities (+/-) of the batteries

match upon installation.

3. Reattach the battery door.

NOTE: Replace batteries when [

] displays,

or when the display is dim.

CLOCK

CLOCK RECEPTION

1. Replace batteries or press and hold [

] but-

ton will initiate RCC receiving.

2. The receiving process duration is 7 minutes.

3. During receiving process, the RCC signal

symbol [

] ashes.

4. If the RCC receiving process is successful, a

completed RCC symbol [

] will be shown

in the display and the date and time will be

set automatically. If it fails within 7 minutes,

RCC setting will quit automatically. If that

happens, press and hold the [

] button to

re-initiate RCC receiving.

5. RCC receiving will automatically start at 2:03,

3:03, 4:03, 5:03 every night. Auto receiving

function will cease if it is successful.

6. To stop RCC reception, press and hold the

[

] button.

7. If the device is still not receiving the signal,

please proceed to set the time manually.

SET THE CLOCK MANUALLY

1. Press and hold [

] button to enter into

time and date setting.

2. The setting parameter will flash.

3. Press [

] button once, the figure will in-

9

EN

IT

DE

FR

ES

crease 1 unit (when setting minute, second

will reset to 0). Press and hold the [

] but-

ton, the figures will increase rapidly.

4. Press [

] button once, the figure will de-

crease 1 unit (when setting minute, second

will reset to 0). Press and hold the [

] but-

ton, the figures will decrease rapidly.

5. Press [

] button to confirm setting and

enter to next parameter.

6. Sequence of setting: Time Zone  12/24 Hr

format  Hour  Minute  Year  Calen-

dar Mode (day-month/month-day)  Month

 Day  Weekday Language  °C/°F 

Exit

7. If there is no action in 20 seconds, the setting

will be saved and will exit the setting mode.

LANGUAGE

The Language options are: English (E), German

(D)  French (F)  Italian (I)  Spanish (S)

TIME ZONE SETTING

To set a different time zone, proceed as follows:

1. Press and hold [

] button, enter time

and date setting.

2. The Time zone offset setting will ash.

3. Press the [

] button to increase or

[

] button to decrease the Time zone off-

set.

°C/°F SETTING

1. Press and hold [

] button, enter time

and date setting.

2. Press [

] button several times until the

display shows °C/°F.

3. Press the [

] or [ ] button to switch Cel-

sius (°C) / Fahrenheit (°F).

ALARM

SETTING/ADJUSTING DUAL ALARM TIME

You can set two alarm times (AL1 and AL2).

10

1. Press the [ ] button to display Alarm 1.

2. Press and hold [

] to enter the alarm set-

ting mode for the currently selected alarm

(Alarm 1).

3. The setting parameter will flash.

4. Press [

] or [ ] button to set the desired

data.

5. Press [

] button to confirm setting and

enter to next parameter.

6. Sequence of setting: Hour  Minute  Vol

H/L (Alarm volume)  Exit

7. Alarm will turn on automatically when alarm

setting is finished.

8. If there is no action in 20 seconds, the setting

will be saved and will exit the setting mode.

TURN ON/OFF ALARM

1. In alarm display mode, press the [

] but-

ton to turn on/off the current alarm. when

in calendar display mode, the sequence

is: AL1 on  AL2 on  AL1+AL2 on 

AL1+AL2 off.

2. The alarm lasts 2 minutes and becomes

faster and faster over time.

OPERATION

1. At the set time, alarm signal rings.

2. During the alarm, press the [

] but-

ton to delay the alarm by 8 minutes.

3. If you do not press any button to stop the

alarm, it will automatically turn off after 2

minutes.

4. To stop the alarm, press [

] or any other

button except SNOOZE.

5. The alarm will start again at the next alarm

time, unless you switch off the alarm func-

tion by pressing the [

] button.

RESET

Press RESET to return to the default settings.

11

EN

IT

DE

FR

ES

SPECIFICATIONS

Dimensions (Main unit):

98x43x97mm (L x W x H)

Weight (Main unit):

180 g

Temperature display range:

-5°C to +50°C (23°F to 122°F)

Accuracy:

10°C to +40°C: +/- 1°C (+/-2°F)

<0° and >+40°: +/- 2°C (+/-4°F)

Resolution:

0.1°C (0.2°F)

Power:

2x AAA (LR03) 1.5V batteries

NOTE

• When the temperature is lower than -5°C

(23°F), the temperature displays LL.L. When

the temperature is higher than 50°C (122°F),

the temperature displays HH.H.

EC DECLARATION OF CONFORMITY

Hereby, Bresser GmbH declares that

the equipment type with part num-

ber: RDC3006 is in compliance with

Directive: 2014/53/EU. The full text of the EU

declaration of conformity is available at the

following internet address: www.bresser.de/

download/RDC3006/CE/RDC3006_CE.pdf

FCC DECLARATION OF CONFORMITY

This device complies with Part 15 of

the FCC Rules. Operation is subject

to the following two conditions: (1)

this device may not cause harmful interfer-

ence, and (2) this device must accept any in-

terference received, including interference

that may cause undesired operation.

12

Please note that changes or modications not

expressly approved by the party responsible

for compliance could void the user’s authority

to operate the equipment.

NOTES ON CLEANING

• Remove the batteries before cleaning.

• Only use a dry cloth to clean the exterior

of the device. To avoid damaging the

electronics, do not use any cleaning uid.

• Protect the device from dust and moisture.

DISPOSAL

Dispose of the packaging materials

properly, according to their type, such as

paper or cardboard. Contact your local

waste-disposal service or environmental au-

thority for information on the proper disposal.

Do not dispose of electronic devices in

the household garbage!

As per the Directive 2002/96/EC of the

European Parliament on waste electrical and

electronic equipment and its adaptation into

German law, used electronic devices must be

collected separately and recycled in an envi-

ronmentally friendly manner.

In accordance with the regulations con-

cerning batteries and rechargeable bat-

teries, disposing of them in the normal house-

hold waste is explicitly forbidden. Please

make sure to dispose of your used batteries

as required by law — at a local collection point

or in the retail market. Disposal in domestic

waste violates the Battery Directive. Batteries

that contain toxins are marked with a sign and a

chemical symbol.

13

EN

IT

DE

FR

ES

Cd¹ Hg² Pb³

1

battery contains cadmium

2

battery contains mercury

3

battery contains lead

WARRANTY & SERVICE

The regular guarantee period is 2 years and

begins on the day of purchase. To benet from

an extended voluntary guarantee period as

stated on the gift box, registration on our website

is required. You can consult the full guarantee

terms as well as information on extending the

guarantee period and details of our services at

www.bresser.de/warranty_terms.

Would you like detailed instructions for this

product in a particular language? Then visit

our website via the link below (QR code) for

available versions. Alternatively you can also

send an email to manuals@bresser.de or

leave a message on +49 (0) 28 72 – 80 74-

220*. Please always state your name, precise

address, a valid phone number and email

address, as well as the article number and

name.

*Number charged at local rates in Germany (the amount you

will be charged per phone call will depend on the tariff of your

phone provider); calls from abroad will involve higher costs.

www.bresser.de/download/RDC3006

MANUAL DOWNLOAD:

www.bresser.de/warranty_terms

SERVICE AND WARRANTY:

Page is loading ...

27

EN

IT

DE

FR

ES

www.bresser.de/download/RDC3006

MANUAL DOWNLOAD:

www.bresser.de/warranty_terms

SERVICE AND WARRANTY:

Page is loading ...

www.bresser.de/warranty_terms

SERVICE AND WARRANTY:

www.bresser.de/download/RDC3006

MANUAL DOWNLOAD:

Errors and technical changes reserved. • Con riserva di errori

e modiche tecniche. • Irrtümer und technische Änderungen

vorbehalten. • Sous réserve d’erreurs et de modications

techniques. • Queda reservada la posibilidad de incluir modica-

ciones o de que el texto contenga errores.

Manual_RDC3006000000_Alarm-clock_en-it-de-fr-es_EXPSC_v112019a

Explore Scientific GmbH

Gutenbergstr. 2 · DE-46414 Rhede · Germany

www.bresser.de · [email protected]

EU

Explore Scientific, LLC

1010 S. 48th Street, Springdale, AR 72762

www.explorescientificusa.com

USA

Explore Scientific Radio-controlled alarm clock Owner's manual

This manual is also suitable for

Explore Scientific Radio-controlled alarm clock Owner's manual

in other languages

Related papers

Other documents