PKG-A SET
4
© Lotronic 2019
damaged by it falling down.
• When using a rack, make sure it is in a stable position and is transported securely. Installation on uneven,
slanted surfaces or stopping the rack abruptly during transport can result in the rack overturning or ap-
pliances falling from or out of the rack and injuring people.
• Live components can be exposed by opening covers or removing components (unless this can be done wit-
hout tools). Contact points can also be live. If the appliance has to be opened in order to calibrate, service,
repair or replace components or assemblies, all of its poles must be disconnected from all sources of voltage
rst. If the appliance has to be kept open and under voltage during maintenance or repairs, this work may
only be carried out by a specialist who is familiar with the risks involved and the relevant regulations.
• Do not place any naked ames such as those of burning candles on or next to the appliance.
• Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the ap-
pliance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This
prevents the dissipation of heat from the appliance and can result in overheating.
• Only use the appliance in a moderate climate, not in tropical environments.
• All persons involved in operating, installing and servicing the appliance and putting it into service must be
trained and qualied accordingly and observe these operating instructions.
• Defective mains cables may only be replaced by specialists. Danger of shock hazard!
DISCONNECTION FROM THE MAINS
• Where the MAINS plug or an appliance couples is used as the disconnect device, the disconnect device shall
remain readily accessible.
• If a switch is used to disconnect the device, the switch and its function must be clearly identied and remain
easily accessible.
FEATURES
• 2-Way 12” or 15” portable Disco speakers with LED illumination
• MP3 player
• LCD display
• SD card slot
• USB connection
• FM radio/Bluetooth
• Equalizer (Bass & treble level control)
• High eciency woofer
• 1” titanium driver
• Supports 16Gb USB/SD drives
INSTALLATION
Plug one end of the supplied SPEAKON lead into the SPEAKER OUT socket of the active box and the other end to
the SPEAKER IN socket of the passive box.
STAND MOUNTING
Observe the following precautions:
• The stand must be placed on a at, level, and stable surface.
• Route cables so that performers, crew, and audience will not trip over them and pull the speaker over.
• Remove the speaker from the stand before moving the stand or adjusting its height.
• Before moving the box, remove all connected cables.
• Do not use the speaker’s handles for suspended installation. Doing so can result in damage and injury.
• Be sure to fully extend the legs of tripod type stands.
• Position the stand so that the legs do not present a trip hazard.
• Do not attempt to place more than one speaker on a stand.
OPERATION
1. Prior to switching the unit on, turn the volume down to minimum.
2. Connect your audio source to the appropriate input socket.