2. Mytee
  3. 8903

Mytee 8903 Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Mytee 8903 Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Assembly Instructions
8903 Wand Style Spinner
®
Tools Required:
•Two 7/16” wrenches or sockets
•Scissors
1.Cutothezip-tieholdingthehosetothe
tube. Use two 7/16” wrenches or sockets to
loosentheboltsonthetubeclampjustenough
to be able to slide the tube up and down.
2. Slide the clamp up towards the top of the
lower tube. Slide the upper tube up until it’s at
acomfortableheight.
3. Rotate the upper tube and clamp so they’re
directly above where the vacuum hose con-
nectstotheplastichead.Tightentheclamp
down when in position.
4. Apply cork spacers to the inside of the
handle assembly if desired. Place the handle
assembly around the upper tube at a com-
fortableheightwiththehandlefacingoutward
toward the front of the Spinner.
5. Slide the four washers on the four bolts and
hand-threadthemintotheholesonthehandle.
Tightenthemdownwiththe7/16”wrenchor
socket.
6. Slide the vacuum relief cap onto the tube.
Slide it down so it covers the vacuum relief
slot.
IF USING 2” HOSE: Slide on the barbed 2”
hoseadapter.2”hosecuslidesoverthe
adapter.
/