Mytee 8903 Assembly Instructions

Assembly Instructions

8903 Wand Style Spinner

Tools Required:

•Two 7/16” wrenches or sockets

•Scissors

1.Cutothezip-tieholdingthehosetothe

tube. Use two 7/16” wrenches or sockets to

loosentheboltsonthetubeclampjustenough

to be able to slide the tube up and down.

2. Slide the clamp up towards the top of the

lower tube. Slide the upper tube up until it’s at

acomfortableheight.

3. Rotate the upper tube and clamp so they’re

directly above where the vacuum hose con-

nectstotheplastichead.Tightentheclamp

down when in position.

4. Apply cork spacers to the inside of the

handle assembly if desired. Place the handle

assembly around the upper tube at a com-

fortableheightwiththehandlefacingoutward

toward the front of the Spinner.

5. Slide the four washers on the four bolts and

hand-threadthemintotheholesonthehandle.

Tightenthemdownwiththe7/16”wrenchor

socket.

6. Slide the vacuum relief cap onto the tube.

Slide it down so it covers the vacuum relief

slot.

IF USING 2” HOSE: Slide on the barbed 2”

hoseadapter.2”hosecuslidesoverthe

adapter.