Graymills Corporation 3705 N. Lincoln Ave. Chicago, IL 60613 USA 773-248-6825 [email protected] www.graymills.com
FILTER KIT INSTRUCTIONS 795-92835_0314
ASSEMBLY INSTRUCTIONS
1. Apply Teflon® tape or pipe compound to all threads
before assembling.
2. Assemble per assembly diagram taking careful note
of the IN and OUT connections cast in the filter.
ASSEMBLY DIAGRAM
FILTER KIT FOR T24 AND T36 SERIES LIFTKLEEN
FOR MODELS C-31626, C-31626-41, C-31626-88
OPERATION
1. Loosen the tensioning bolt (A) and wiggle the filter
vessel (5) to break the seal and bleed entrapped air.
2. Tighten when liquid appears.
NOTE
If leakage occurs, further tightening of the bolt
will only stretch it without improving seal. Remove
shell and lubricate the gasket (16) with a suitable
lubricant. If leakage continues, replace the gasket.
3. Replace the filter cartridge (6) when flow drops
below an acceptable point.
1 Filter mounting bracket (stainless) 663-42355-81
2 Hex (stainless) 752-01263-81
3 Lock Washer (stainless) 754-00595-81
4 Flat Washer (stainless) 754-90108-81
5 Filter Vessel 742-07937
6 Filter Cartridge 742-07955-1
Case of Filter Cartridges (30) 742-07955
7 Elbow, 3/4 NPT x 90 724-00576
8 Brass Locknut 724-04613-41
9 Nipple, 3/4 NPT x 90 720-02792-13
10 Vincon Tube, 3/4 ID 729-04369
11 Hose Clamp (stainless) 733-04698-81
12 Male Insert, 3/4 NPT (brass) 730-03841-41
12 Male Insert, 3/4 NPT (nylon) 730-04665
13 Reducer Bushing (stainless) 724-03704-81
13 Reducer Bushing (brass) 724-03704-41
*Not required on mild pump assembly
14 Barbed Elbow, 3/4 NPT 730-04769
15 Cap Nut Gasket (Buna-N) 745-07996
15 Cap Nut Gasket (Viton) 745-92664
16 O-Ring, 3-1/2” (Buna-N) 744-07997
16 O-Ring, 3-1/2” (Viton) 744-92664
17 Hex Nut (stainless) 755-00594-81
No. Description Part Number No. Description Part Number
/