Lambro 222W Installation guide

  • I have reviewed the provided installation instructions for the Vent. This document covers the steps necessary to install the vent, including cutting the hole, positioning the pipe, and securing it to the wall. I'm ready to answer any questions you have about installing and maintaining this vent.
  • What size hole needs to be cut?
    How is the vent secured to the wall?
    Where should the vent be installed?
C
A
L
I
D
A
D
D
E
S
D
E
1
9
6
7
Q
U
A
L
I
T
Y
S
I
N
C
E
1
9
6
7
Q
U
A
L
I
T
E
D
E
P
U
I
S
1
9
6
7
Cut a 3 1/4” hole through the outside wall or use existing hole.
Corte un orificio de 8.2 cm pulgadas a través de la pared exterior o use un
orificio existente.
From the outside, slide pipe through the hole opening until the vent is
flush against outside wall surface.
Del exterior, la pipa de la diapositiva con la abertura del agujero hasta la
campana preferida es rasante contra superficie exterior de la pared.
Secure to outside wall using 4 screws (Not Included). Caulk around vent
and outside wall if necessary.
Se fija a la pared exterior usando 4 tornillos (no se incluyen). Si es
necesario, calafatee alrededor de la ventila, entre ésta y la pared exterior.
1
2
3
Installation Instructions:
Check and comply with local building codes.
Instrucciones de instalación:
Revise y cumpla los codigos locales de construccion.
Warning: This unit should be installed in an accessible
location so lint can be cleaned periodically from the screen.
Advertencia: Esta unidad se debe instalar en una
localización accesible así que la pelusa se puede limpiar
periódicamente de las pantalla.
/