Cuisinart SS-5P1 Operating instructions
- Category
- Coffee making accessories
- Type
- Operating instructions
Compact Single-Serve Coffeemaker
Setup instructions continued inside
For more helpful hints see Instruction Booklet
QUICK REFERENCE GUIDE
TROUBLESHOOTING GUIDE
SETUP
PG-34061 ©2015 Cuisinart
Soak lter fully immersed
in cold tap water for 15
minutes. Place the charcoal
water lter in the holder
and snap the holder cover
closed. Flush lter and
holder by running fresh
water through the hole in
bottom of compartment
for 10 seconds.
Make sure to remove all
packing tape, stickers and
polybags from the brewer.
Remove the water reservoir
and clean inside with a
damp, lint-free cloth. Plug
the brewer into a grounded
outlet.
Allow the lter to drain
completely. Place the
assembled water lter
holder into the water
reservoir. Push it down
to t into place.
Problem: Solution:
Brewer does
not have power.
Plug brewer into an independent outlet.
Make sure the brewer is securely plugged in.
Plug into a different outlet.
Reset your home’s circuit breaker.
Confirm the power has been turned on and the On/Off and brew buttons are
illuminated.
Brewer will
not brew.
Turn off and unplug the brewer for 30 seconds or more. When you plug the
brewer back in, be sure to turn the power back on.
If the Add Water indicator is illuminated, check to make sure the water
reservoir is properly filled. If not, add at least 12 oz. of water. If the Add Water
indicator is illuminated even after adding at least 12 oz. of water to the water
reservoir, contact Consumer Service at 1-800-726-0190.
The exit needle may be clogged (see page 12 of the Instruction Booklet).
Make sure brew head is fully closed.
Chlorine or mineral
taste in coffee.
Consider using bottled water, filtered water or replacing the Cuisinart
Charcoal Water Filter.
Brewer doesn’t brew
a full cup.
Turn off and unplug the brewer for 30 seconds or more. When you plug the
brewer back in, be sure to turn the power back on.
The exit needle may be clogged (see page 12 of the Instruction Booklet).
Clean the brewing chamber (refer to Cleaning and Maintenance, page 12 of
the Instruction Booklet).
De-scale the brewer (refer to page 13 of the Instruction Booklet). If you have
repeated the de-scaling procedure two times and it is still brewing only a
partial cup, contact Consumer Service at 1-800-726-0190.
Coffee is too
weak or watery.
Consider brewing a smaller cup size or try an Extra Bold capsule. It has 30%
more ground coffee in each portion pack.
All lights are flashing
in sequence when
turning on unit.
De-scale the brewer (refer to page 13 of the Instruction Booklet). If you have
repeated the de-scaling procedure two times and it is still brewing only a
partial cup, contact Consumer Service at 1-800-726-0190.
3.
2.
1.
Fill the reservoir with water.
Press the Power button to turn
the unit on. The Power button and
the Brew buttons will illuminate.
Place mug on drip tray and place
a capsule in the brewing chamber.
Close brew head and select brew size,
pressing desired Brew button: 6 oz.,
8 oz. or 10 oz.
CAUTION: Avoid putting your ngers
in capsule chamber. Puncture needles
are located above and below capsule
chamber.
The Brew button LED that you
selected will ash, indicating the
water is heating. The beverage will
start to dispense momentarily.
CAUTION: There is very hot water
in the brewing chamber during
the brewing process. To avoid risk
of injury, do not lift the handle or
open the brewing chamber during
the brewing process.
The one-time setup process is complete.
Enjoy your cup of coffee, tea or hot cocoa!
BREWINGSETUP INSTRUCTIONS (CONTINUED)
IMPORTANT
Do not throw these instructions away. Read before operating your
new brewing system. Keep for future reference.
These helpful hints are intended to be a supplement to the Instruction Booklet.
In order to ensure safe operation and optimum performance,
please read the entire Instruction Booklet.
1.
2.
3.
Press the 10-ounce Brew
button. The 10-ounce
button will start ashing
and the water will start
to dispense momentarily.
The one-time cleaning
process is complete.
Discard hot water. Your
brewer is ready to use.
6.
Open and close the
brew head. Do not add
a capsule. Place a mug
on the drip tray.
5.
Fill the reservoir with water.
Press the Power Button
to turn the unit on. The
Power button and the Brew
buttons will illuminate.
4.
-
1
-
2
Cuisinart SS-5P1 Operating instructions
- Category
- Coffee making accessories
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI