CLEANING:
• Protective silicone cover and mounting bracket (only); hand wash with cold water, a mild
dishwashing detergent and thoroughly air dry
WARRANTY:
• Magma Products, Inc. warrants this product to be free of defects in materials and/or work-
manship for a period of 1 year from the date of original purchase (proof of purchase required).
e,
outside storage; discoloration from sun exposure, any weather related damages, general
neglect, and/or misuse by the user.
• Magma must approve all product warranty claims.
• Magma reserves the exclusive right to repair and/or replace any product or component
defective
in material or workmanship during the warranty period.
• Warranty claims; Do Not contact or return this product to retailer. Prior to returning product
contact Magma Products, Inc. directly for return authorization and instructions.
• Returning warranty claims; user is responsible for all shipping charges.
Care and Use: A10-141 LED Grill Light
Contents
MAGMA PRODUCTS, INC. • 3940 Pixie Ave.
Lakewood, CA 90712 • USA • Tel: (562) 627-0500
MagmaProducts.com • [email protected]
C A U TIO N :
To prevent overheating light
fold back out of direct heat
source during extended use
SAFETY:
• When grilling do not leave lid open with light
bracket in open position for extended periods
of time, leaving lid open for extended periods
of time with light bracket open will cause light
to become hot.
• Always use hot pad or oven mitt when handling
hot grill.
INSTALLATION / ASSEMBLY INSTRUCTIONS
USE:
• Prior to use; ensure light is properly assembled,
installed to mounting bracket, and grill lid handle.
• Open grill lid, turn light on & extend/adjust light bracket
to the proper location to illuminate grilling surface.
• Never leave light attached to grill when not in use.
• Never use light without protective silicone cover.
• Never leave light in direct sunlight for extended periods of time.
Replacing battery
Note: Roll back black rubber piece for
convenient disassembly & reassembly
Remove
large rubber
insert
83-141 1211
Step 2 For installing on to cast handle
Removing
light from
bracket
Step 2 For installing to tubular handleStep 1 Unlock clamp
Step 3 Locking
to handle
I N S T A L L A T I O N
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Magma A10-144 Care and Use Manual
-
-
-
-
Monterey A10-1225 User manual
-
Newport A10-918NZ-3 Owner's manual
-
-
-
-
