Hydro Crunch K1-B1-R18-L0405 Operating instructions

Brand: Hydro Crunch

Model: K1-B1-R18-L0405

Type: Operating instructions

Instruction Manual

Double Ended

Cool Tube Hood Reflector

Parts List

3 –Middle reflector

4 –End reflectors

1 –Cool Tube

4 –Corner steel plates

30–M4 nuts

46–M4*8 Wing screws

Reflector Assembly

How to Assemble

1. Use 28 sets wing screws and 12 nuts to attach the middle aluminum and side aluminum.

2. Use rest 18 sets wing screws and nuts to connect the middle steel plates to the side aluminum

reflector.

3. Finish the assembly and hang the reflector with rope hangers.

Lamp Installation

1. Open up both the cover of lamp holders.

2. Install the lamp after the lamp is locked by latch.

3. Once lamp is positioned correctly close the cover of the lamp holders to secure and lock the lamp in

place.

4. Installing the double ended lamp within the lamp holders shown in the following photos below.

Please note: During installation try to minimize excessive handling of the lamp to minimize fingerprints and

oils left on the lamp. If the lamp needs cleaning use a soft dry cotton cloth to wipe of finger prints or oils.

ATTENTION：Please make sure the wire of the lamp is straight when you install the lamp. If not, the lamp

will not connect securely with the socket.

1 Year Limited Warranty Service

If the product will not work after you have read the troubleshooting guide and practiced the

troubleshooting options, you are advised to return the Hydro Crunch™ light system to the retailer you

purchased it from. The dealer will be able to examine the light and test its components. If they are not able

to repair the light, they will return it to us for examination and repair/replacement. Do not attempt to

repair any product on your own, as serious injury or death may result. If the retailer is not able to help you

and the light is still under manufacturer’s warranty, you may contact us for technical support. In some cases,

you will be issued an RMA# (return merchandise authorization number) to return the unit for factory repair.

Complete the warranty form below and return the light with all original packaging, your receipt of purchase,

and a valid RMA# to the address below. Please pack and ship the light in its original packaging. If it is

damaged in shipment we cannot be responsible and the warranty may be voided. Once we receive RMA

package, it will be repaired or replaced and shipped back to you. Please note if an additional warranty was

purchased and include the extended warranty sales receipt with your return.

RETURN FORM

Include the following if returning:

 Proof of purchase

 This completed form

 RMA# on the outside of the box

 Extended warranty receipt

Return Merchandise Authorization Number (Required): ___________________________________

Contact Name: _____________________________________________________________________

Address: __________________________________________________________________________

__________________________________________________________________________________

Phone #: __________________________________________________________________________

Email Address: _____________________________________________________________________

Please give a brief description of your technical issue: _____________________________________

__________________________________________________________________________________

SEND TO:

Hydro Crunch

17128 Colima Road Suite 510

Hacienda Heights, CA 91745

714-516-8176

Hydro Crunch K1-B1-R18-L0405 Operating instructions

Hydro Crunch K1-B1-R18-L0405 Operating instructions

Hydro Crunch K1-B1-R18-L0405 Operating instructions

Related papers

Other documents