Contec PC-HDD100S Owner's manual

Brand: Contec

Model: PC-HDD100S

Type: Owner's manual

2.5-inch 100GB SATA Hard Disk Drive

PC-HDD100S User’s Guide

CONTEC CO.,LTD.

Thank you for purchasing the CONTEC PC-HDD100S.

Please use this product in accordance with the procedures described in this document. This product can be used for the

CONTEC’s following models. (Don’t use this product with any other devices.)

-PC-HDD100S

BOX Computer: BX-710xx-ACxxxx, BX-100n-DCxxxx-C01, BX-110n-DCxxxx-C01, BX-960D-DCxxxx *1,

BX-1000xx-ACxxxxx*1

、

BX-961D-DCxxxx*1

Panel Computer PT-955LS-ACxxxx

Digital Signage Player: DS-960D-DCxxxx *1

*1 When using this device with BX-960D-DCxxxx, BX-1000xx-ACxxxxx

、

BX-961D-DCxxxx, or DS-960D-DCxxxx,

let Power On Hour less than 3,000 hours/year.

Package Contents

- Hard Disk Drive [PC-HDD100S] …1 - Warranty Certificate …1

- User’s Guide (this sheet) …1 - Serial number label …1

Disposal

When disposing of the product, follow the disposal procedures stipulated under the relevant laws and municipal

ordinances.

Safety Information

This document provides safety information using the following symbols to prevent accidents resulting in injury or death

and the destruction of equipment and resources. Understand the meanings of these labels to operate the equipment safely.

DANGER

DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING

WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or in

property damage.

Disclaimers

We shall not be liable for any consequential damages such as losses and lost profits resulting from the operation of this

product. For any reason we shall provide no warranty for the stored contents on your hard disk.

Handling Precautions

CAUTION

- Do not apply pressing force on the top of cover.

- Do not cover the breathing hole on the top cover.

- The system is responsible for providing sufficient air movement to maintain surface temperatures below 90°C on the

top cover

- Do not touch the interface connector pins and the surface of printed circuit board.

- Hard disk is precision instruments. Be extremely careful in handling during and after assembly.

- Hard disk can malfunction when it is subjected to electrostatic discharge (ESD) or physical shock. Handle with care so

that antistatic measures are taken in advance and do avoid shock.

- Be sure to turn off the power of the unit when plugging in or unplugging interface connectors.

- CONTEC bears absolutely no responsibility for use if modified hard disk.

- Excessive vibration or impact greater than its specification, if this hard disk is subjected to, might cause a fatal error that

is not recoverable.

- Service life of the drive is approximately 5 years or 30,000 power on hours, whichever comes first.

These are the standard values when the environmental and operational conditions specified in page 3 are observed and

are not the guaranteed values.

Specification

Item Specification

Total recording capacity 100GByte

Host interface Serial-ATA Revision 2.6 (1.5Gbps)

Transfer velocity

Max. 753Mbit/sec

Typ. 323 - 665Mbit / sec

Input voltage +5VDC (±5%)

Consumed power

Sleep 0.13W (typ.)

Read / Write / Seek 2.0W / 2.0W / 2.3W (typ.)

Startup *1 5.5W (Max.)

Environment

Operating

Te m p e r a t u r e

-30 - 85°C

Humidity 5 - 90%RH (With no condensation)

Maximum wet bulb

temperature

40°C (With no condensation)

Temperature change

gradient

180°C/h or less for up

60°C/h or less for down

(With no condensation from temperature gradient)

Altitude 1049.8hPa - 494.9hPa (Above the sea -300 - 5,650m)

Swept sine vibration

3.0G or less (8 - 50Hz)

2.5G or less (50 - 200Hz)

2.0G or less (200 - 500Hz)

Shock

300G or less (2ms)

100G or less (11ms)

Non-operating

Temperature -40 - 95°C

Humidity 5 - 95%RH (With no condensation)

Maximum wet bulb

temperature

42°C (With no condensation)

Temperature change

gradient

上180°C / h or less for up

60°C / h or less for down

(With no condensation from temperature gradient

Altitude 1049.8hPa - 193.3hPa (Above the sea -300 - 12,000m)

Swept sine vibration 5.0G or less (10 - 500Hz)

Shock 800G or less (1ms)

Operational

condition

Power on hours *2 24hours/day, 8,760hours / year or less

Read / Write / Seek 20% or less at power on hours

Number of seek 1.30 x 10

seeks / month

Disk enclosure surface -30 - 70°C

MTTF 300,000H

Physical dimensions (mm) 69.85 (W) x 100.0 (D) x 9.5 (H)

Weight 98g (Max.)

*1 Maximum power consumption at motor startup

*2 When using this device with BX-960D-DCxxxx, BX-1000xx-ACxxxxx

、

BX-961D-DCxxxx, or

DS-960D-DCxxxx, let Power On Hour less than 3,000 hours/year.

Fixed disk characteristics

Number of

Disks

Number

of Heads

Number of Cylinders Bytes per Sector Formatted capacity (GB)

PC-HDD100S 1 1 154,800 512 100.030

Physical Dimensions

CONTEC CO.,LTD.

3-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan

July 201

Editio

Japanes

http://www.contec.co.jp

English http://www.contec.com

Chinese http://www.contec.com.cn/

NA01926 (LYNY652

)

[0701201

]

o part of this document may be copied or reproduced in any form by any means without prior written consent of CONTEC CO., LTD.

Contec PC-HDD100S Owner's manual

Contec PC-HDD100S Owner's manual

Contec PC-HDD100S Owner's manual

Related papers

Other documents