Mi-T-M Sand Injector is a device that can be used for a variety of surface preparation tasks, such as removing paint, rust, and scale. It can also be used for sandblasting wood to create a course, rough cut effect, or a smoother, driftwood effect. The injector can be used with a pressure washer and has a maximum working pressure of 5500 PSI and a minimum working pressure of 1500 PSI. It has a maximum flow rate of 10 GPM and a minimum flow rate of 3 GPM, and can handle sand mesh sizes from 10/35 to 40/60. The injector comes with a 25 ft. hose and a variety of nozzles for different applications.
Mi-T-M Sand Injector is a device that can be used for a variety of surface preparation tasks, such as removing paint, rust, and scale. It can also be used for sandblasting wood to create a course, rough cut effect, or a smoother, driftwood effect. The injector can be used with a pressure washer and has a maximum working pressure of 5500 PSI and a minimum working pressure of 1500 PSI. It has a maximum flow rate of 10 GPM and a minimum flow rate of 3 GPM, and can handle sand mesh sizes from 10/35 to 40/60. The injector comes with a 25 ft. hose and a variety of nozzles for different applications.
Mi-T-M Sand Injector is a device that can be used for a variety of surface preparation tasks, such as removing paint, rust, and scale. It can also be used for sandblasting wood to create a course, rough cut effect, or a smoother, driftwood effect. The injector can be used with a pressure washer and has a maximum working pressure of 5500 PSI and a minimum working pressure of 1500 PSI. It has a maximum flow rate of 10 GPM and a minimum flow rate of 3 GPM, and can handle sand mesh sizes from 10/35 to 40/60. The injector comes with a 25 ft. hose and a variety of nozzles for different applications.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI