ET2 E23257-20PC Installation guide

Brand: ET2

Model: E23257-20PC

Type: Installation guide

PRODUCT NAME: BANGLE

ITEM NUMBER: E23257-20PC

PRODUCTS ARE NOT INENDED

FOR COMMERCIAL USE

MADE IN CHINA

Page 1 of (3)

C o n t e m p o r a r y

L i g h t i n g

Bulbs (Included): 12 x 25 Watt G9

Caution: Xenon bulbs get very hot and

may burn you. Always make sure bulbs

are off for a minimum of 10 minutes

before handling. Fixture may be dimmed

using an electronic low voltage dimmer.

Please consult your electrician for hanging fixture and wiring.

IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation

Locate all hardware & components before discarding packaging

Cleaning & Care:

Page 2 of (3)

Clean with soft cloth and a mild detergent.

Do not use abrasive cleaner.

1.)

Remove mounting bracket (A) from

Canopy (C) to install to electrical box

2.)

Step.2:

Wire fixture to wires in outlet box. Green

wire is for Ground.

Step.1:

Step.3:

Screw finials (D) onto mounting bracket

(A) until canopy is flush with ceiling.

Step.4:

Hang Crystal According to Diagram on the

next page.

3.)

4.)

(D)

Fin al

(F)

G9 Bulb

(B)

Anchor Bolts

(C)

Canopy

(A)

Mounting Bracket

Model E23257-20PC

Crystal Diagram

C-24(L:4.9")

ECRY23257-SB3

B-8(L:3.6")

ECRY23257-SB2

A-40(L:2.7")

ECRY23257-SB1

D-8(L:5.5")

ECRY23257-SB4

F-1(L:7.32")

ECRY23257-SA4

E-4(L:6.55")

ECRY23257-SB5

Page 3 of (3)

ET2 E23257-20PC Installation guide

ET2 E23257-20PC Installation guide

ET2 E23257-20PC Installation guide

Related papers

Other documents