Feature And Application
1. Utilize CAD optimized design ,good and graceful looking.
2. Centrifugal misting system means no nozzles and filter water, with reasonable structure
and simple maintenance.
3. Fan surface is epoxy resin coated, anti-rust and durable. The fan electrical components
are designed to be waterproof. Safe to use, with tank cart, easy to move.
4. Air supplying, misting and oscillating functions are driven by different motors. Motors
adopt high quality ball bearings, with advantages of stable, low temperature-rise, long
service life, low noise, and strong overloading ability.
5. The misting function is controlled by an independent switch, with good misting effect
and adjustable misting volume.
6. Fan is equipped with independent control oscillation device . Convenient and reliable
for use.
7. Designed for cooling, dedusting and deodorizing in factories, residential areas, shopping
malls , athletic fields, livestock farms, greenhouses, paper mills, tobacco factories and
more.
Operating Instructions
1. Apply the fan complied to the voltage and frequency shown on the rating label. Do not
use in corrosive environment.
2. When socket is used in power supply, the socket should meet the IEC335-1 standard.
When power liner is from direct power supply, a polarity switch should be installed with
contact gap not less than 3mm on the fixation wiring.
3. Oscillating angle adjustment: Loosen hand wheels on the fan left side and right side.
Move it to the desired angle and tighten hand wheels.
4. Make sure two casters locked and tank is filled with certain amount of water before
using the misting mode.
5. Filled with certain amount of water, then connect the power supply of the fan and press
the fan button to run the fan motor. Press misting button to run misting motor and water
pump. By pressing oscillating button, the fan will automatically oscillate.
6. Misting adjustment between "OFF" and "ON" when the fan runs with misting .
7. The fan can operate continually for 8 hours with the maximum misting volume when
the fan runs with misting . Re-fill the tank to achieve the misting effect when it is short
of water.
8. In the use of water tank cart, DO NOT force to push the tank cart before opening the
bake of the caster. Close the bake of the caster when stopping the tank cart. DO NOT stop
the tank cart at the slope to prevent sliding forward.
9.Clean the tank each time before use. Take out the water pump before clean . Pour out the
water after clean.
10.Press the misting button to cut off the power supply between misting motor and water
pump, and the fan can be used for blowing.
Wiring Diagram
White
Oscillation button
Fan button
Misting button
N
L240V~
50Hz
Communal winding(Brown)
Primary winding(red)
Secondary winding(Blue)
Earth wire(Yellow/Green)
Capacitor
Communal winding(black)
Primary winding(red)
Secondary winding(Yellow)
Communal winding(black)
Primary winding(Brown)
Secondary winding(Blue)
Thermic fuse
Capacitor
Capacitor
Black Black
Black Black
Brown
Brown
Brown
Blue
Pump
Misting Fan motor
Oscillation
motor
Black
White
Purple
Earth wire(Yellow/Green)
Brown
Blue
N
N
motor
800
(m /min)
Model
Parameter
Air flow
Speed
Item
(rpm)
IMF-600 90
Oscillating
angle
Noise
70
(dB)
Power
(W)
3
(℃)
910
Misting
L/h
10
Air
pressure
(Pa)
160 90
volume
(Max)
remark:we don't notify you if above technology parameter change
N
Thermic fuse