2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. NOREGON
  6. 3.0

NOREGON 3.0 User guide

  • Hello! I've reviewed the user guide for the Allison Transmission USB Translator 3.0. This document covers the installation of drivers and the proper connection of the device to both a computer and a vehicle. I'm ready to assist you with any questions you may have about setting up and using the device.
  • How is the adapter powered?
    Where can I download the adapter drivers?
    What is the first step for installation?
4*
76
*Ensure that the USB cable is firmly
seated into the adapter’s USB port
5
Close running applications.
Users can download adapter drivers online by visiting www.noregon.com/adapter-drivers and clicking the
“Assets and Driver Download” button from the “USB Translator 3.0” section of the adapter
driver landing page.
Once the download is complete, launch the installer and follow the prompts.
CONNECT:
Connect the D89 end of the USB cable to the port labeled Computer on the USB Translator 3.0 Adapter.
Plug the other end of the USB cable into the USB port on the PC.
Connect the diagnostic cable to the 26-pin connector on the USB Translator 3.0 Adapter.
Attach the diagnostic cable’s connector to the diagnostic port on the vehicle.
1
2
3
4
5
6
7
INSTALL DRIVERS:
Adapter is powered by the vehicle
and must be connected to operate.
NOTE:
QUICKSTART GUIDE
QSG-USBT3.0-2023-03-081423
3.0
4*
6
allisonstore.noregon.com
To order additional cables or
replacement parts, visit:
/