Maxell ME-M23D User manual

Brand: Maxell

Model: ME-M23D

Type: User manual

Maxell ME-M23D is a wireless module that enables communication between devices using radio waves. It complies with FCC Part 15 regulations and requires integration into a host device for operation. The module features an exclusive antenna cable with a ferrite core for improved signal quality. It supports data transmission and reception and is designed for use in various applications, including wireless data transfer and communication systems.

MAXELL CONFIDENTIAL

Cautions

・Since this module is not sold to general end users directly, there is no user manual

of module.

・For the details about this module, please refer to this specification sheet of module.

・This module should be installed in the host device according to the interface

specification (installation procedure).

・This module complies with below part 15 of the FCC Rules.

Part 15 Subpart C

・The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC

transmitter rules) listed on the grant, and the host product manufacturer is responsible

for compliance to any other FCC rules that apply to the host not covered by the

modular transmitter grant of certification.

The final host product still requires Part 15 Subpart B compliance testing with the

modular transmitter installed.

・Display the following on the final product.

①Contains Transmitter Module FCC ID: UOEME-M23D

②This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

・Display the following on the User Manual of final product.

①Properly shielded and grounded cables and connectors must be used for connection

to host computers and / or peripherals in order to meet FCC emission limits.

②FCC CAUTION：Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

MAXELL CONFIDENTIAL

3.3 Appearance of Exclusive Antenna Cable

Appearance of exclusive antenna cable is shown below.

Cable length : 500 mm (standard value)

Connector housing: For PH-2pin

Ferrite core : TDK ZCAT1325-0530A 1 turn

Fig. 3-3 Appearance of Exclusive Antenna Cable

500±15mm Antenna side

Reader/Writer side

100 mm

3.6 Ferrite Core Recommended Position

Fig. 3-6 Figure of Host communications cable ferrite core placement

PH-5pin(Reader/Writer Side)

50mm

RS-232C(Host Side)

Ferrite Core

TDK ZCAT1518-0730 1 turn

Maxell ME-M23D User manual

Maxell ME-M23D User manual

Maxell ME-M23D User manual

Other documents