Dobinsons Springs and Suspension
Hollingsworth Street
Australia/USA/UAE
58 Hollingsworth Street
NORTH ROCHAMPTON QLD AUSTRALIA
admin@dobinsonsprings.com
Reservoir Install Instructions
NOTE – Installation is always recommended by a competent technician. Failure to properly install may result in
reservoir fouling on components and voiding warranty.
WARNING:
• Do not let gas out of shocks unless you have the ability to re-charge the shocks.
• Care must be taken to ensure the external oil reservoir does not foul on any components over the full
travel.
• Operation outside of the working range may cause damage to the arm and could result in component
failure, Warranty may also be voided.
Washer Sequence
Fitment
Part Number
Toyota Landcruiser 100
MRA59-A782
MRA59-A786
Dobinsons Springs and Suspension
Hollingsworth Street
Australia/USA/UAE
58 Hollingsworth Street
NORTH ROCHAMPTON QLD AUSTRALIA
admin@dobinsonsprings.com
1. Mount shock absorber as per original configuration with the body at the top and the rod at the
bottom.
2. Make sure the hose is facing slightly forward as per below picture.
3. Mount the bracket into location shown with hose and res as per picture.
Other fitting Notes
Make sure top nut is tight.
Please check the reservoir and the hose clear all arms etc on full travel up and down.
Place all stickers on the shock to outside of car for maximum visual effect.
Put on zipties to hold the dust cover in position.
FORWARD
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Belshaw Brothers 634 User manual
-
WEG Variable Speed Drive CFW11 User manual
-
-
-
Bettis M11S-S Hydraulic Control System For "G" Series Spring Return Actuators Operating instructions
-
-
Shafer SH-Series Poppet Block Owner's manual
-
-
-
