2. Dobinsons
  3. MRA59-A782

Dobinsons MRA59-A782 Installation guide

  • Hello! I've reviewed the installation instructions for the Dobinsons shock absorbers, models MRA59-A782 and MRA59-A786. This document highlights the importance of professional installation and outlines how to mount the external oil reservoir correctly. I'm ready to answer your questions about the installation process and key considerations for these shock absorbers.
  • What should I do if I don't have experience with installing shock absorbers?
    What happens if the external oil reservoir touches other components?
    What should I check after i mount the bracket?
Dobinsons Springs and Suspension
Hollingsworth Street
Australia/USA/UAE
58 Hollingsworth Street
NORTH ROCHAMPTON QLD AUSTRALIA
admin@dobinsonsprings.com
Reservoir Install Instructions
NOTE – Installation is always recommended by a competent technician. Failure to properly install may result in
reservoir fouling on components and voiding warranty.
WARNING:
• Do not let gas out of shocks unless you have the ability to re-charge the shocks.
• Care must be taken to ensure the external oil reservoir does not foul on any components over the full
travel.
• Operation outside of the working range may cause damage to the arm and could result in component
failure, Warranty may also be voided.
Washer Sequence
Fitment
Part Number
Toyota Landcruiser 100
MRA59-A782
MRA59-A786
Dobinsons Springs and Suspension
Hollingsworth Street
Australia/USA/UAE
58 Hollingsworth Street
NORTH ROCHAMPTON QLD AUSTRALIA
admin@dobinsonsprings.com
1. Mount shock absorber as per original configuration with the body at the top and the rod at the
bottom.
2. Make sure the hose is facing slightly forward as per below picture.
3. Mount the bracket into location shown with hose and res as per picture.
Other fitting Notes
Make sure top nut is tight.
Please check the reservoir and the hose clear all arms etc on full travel up and down.
Place all stickers on the shock to outside of car for maximum visual effect.
Put on zipties to hold the dust cover in position.
FORWARD
/