DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts Owner's manual

Category
Car subwoofers
Type
Owner's manual

DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts is a high-powered subwoofer that is perfect for adding bass to your car audio system. With a peak power handling of 1800 watts, this subwoofer can produce deep, powerful bass that will fill your car with sound. The ported box design helps to extend the bass response, giving you even more low end.

This subwoofer is also very easy to install. It comes with all the necessary hardware, and the instructions are clear and concise. You can have this subwoofer up and running in no time.

Here are some of the key features of the DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts:

DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts is a high-powered subwoofer that is perfect for adding bass to your car audio system. With a peak power handling of 1800 watts, this subwoofer can produce deep, powerful bass that will fill your car with sound. The ported box design helps to extend the bass response, giving you even more low end.

This subwoofer is also very easy to install. It comes with all the necessary hardware, and the instructions are clear and concise. You can have this subwoofer up and running in no time.

Here are some of the key features of the DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts:

12''
OWNER'S MANUAL
GEN-X212LD
SUBWOOFER
IN A PORTED BOX
2x12''
LOADED SUBWOOFER ENCLOSURE
1
General
Total Impedance . . . . . . . . . . . . . . . . . . . . . . 2 + 2 ohm
(Individual Subwoofer Connector)
Total RMS Power Handling . . . . . . . . . . . . . 900W
Total MAX Power Handling . . . . . . . . . . . . . 1800W
Sensitivity (1w/1m) . . . . . . . . . . . . . . . . . . . . 94dB
Frequency Response . . . . . . . . . . . . . . . . . . . 29 - 250Hz
Recommended Lo Pass Crossover. . . . . . . 120Hz
Speaker Specifications
2 x 12" GEN-X124D Subwoofer
Voice Coil Diameter . . . . . . . . . . . . . . . . . . . . 2"
Voice Coil Former Material . . . . . . . . . . . . . Black Aluminum
Winding Material . . . . . . . . . . . . . . . . . . . . . . SV
Cone Material . . . . . . . . . . . . . . . . . . . . . . . . . Paper & Fiber Glass
Dust Cap Material . . . . . . . . . . . . . . . . . . . . . . PPI
Surround Material. . . . . . . . . . . . . . . . . . . . . . Foam
Basket Material . . . . . . . . . . . . . . . . . . . . . . . . Steel
Magnet Material . . . . . . . . . . . . . . . . . . . . . . . Ferrite
Magnet Weight . . . . . . . . . . . . . . . . . . . . . . . . 70 Oz
Box Specifications
Internal Volume. . . . . . . . . . . . . . . . . . . . . . . . 90.6L
Port Tune. . . . . . . . . . . . . . . . . . . . . . . . . Fb. . 35Hz
Load Configuration . . . . . . . . . . . . . . . . . . . . Parallel
Box Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Front Ported
Box Material . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/2" MDF
Finish Material . . . . . . . . . . . . . . . . . . . . . . . . . Vinyl
-3dB Dropping Point . . . . . . . . . . . . . . F3. . 29Hz
Measurement
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13.78” / 350mm
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38.58” / 980mm
Depth 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11” / 280mm
Depth 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14” / 356mm
GEN-X212LD
SPECIFICATIONS
LOADED SUBWOOFER ENCLOSURE
General
Total Impedance . . . . . . . . . . . . . . . . . . . . . . 2 + 2 ohm
(Individual Subwoofer Connector)
Total RMS Power Handling . . . . . . . . . . . . 900W
Total MAX Power Handling . . . . . . . . . . . . 1800W
Sensitivity (1w/1m) . . . . . . . . . . . . . . . . . . . 94dB
Frequency Response . . . . . . . . . . . . . . . . . . 29 - 250Hz
Recommended Lo Pass Crossover. . . . . . 120Hz
Speaker Specifications
2 x 12" GEN-X124D Subwoofer
Voice Coil Diameter . . . . . . . . . . . . . . . . . . . 2"
Voice Coil Former Material . . . . . . . . . . . . Black Aluminum
Winding Material . . . . . . . . . . . . . . . . . . . . . SV
Cone Material . . . . . . . . . . . . . . . . . . . . . . . . Paper & Fiber Glass
Dust Cap Material . . . . . . . . . . . . . . . . . . . . . PPI
Surround Material. . . . . . . . . . . . . . . . . . . . . Foam
Basket Material . . . . . . . . . . . . . . . . . . . . . . . Steel
Magnet Material . . . . . . . . . . . . . . . . . . . . . . Ferrite
Magnet Weight . . . . . . . . . . . . . . . . . . . . . . . 70 Oz
Box Specifications
Internal Volume. . . . . . . . . . . . . . . . . . . . . . . 90.6L
Port Tune. . . . . . . . . . . . . . . . . . . . . . . . . Fb. . 35Hz
Load Configuration . . . . . . . . . . . . . . . . . . . Parallel
Box Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Front Ported
Box Material . . . . . . . . . . . . . . . . . . . . . . . . . . 1/2" MDF
Finish Material . . . . . . . . . . . . . . . . . . . . . . . . Vinyl
-3dB Dropping Point . . . . . . . . . . . . . . F3. . 29Hz
Measurement
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13.78” / 350mm
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38.58” / 980mm
Depth 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11” / 280mm
Depth 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14” / 356mm
Total Impedance . . . . . . . . . . . . . . . . . . . . . . 2 + 2 ohm
GEN-X212LD
38.58” / 980mm
13.78” / 350mm
2
Total Impedance . . . . . . . . . . . . . . . . . . . . . . 2 + 2 ohm
DIMENSIONS
11.08” / 281.42mm
14.09” / 357.76mm
3
4
Professional installation by an
authorized DS18 dealer is highly
recommended! Otherwise, the
performance of your new gear may not
be satisfactory. In the event
that you decide to do your own
installation, please read and follow this
manual carefully.
Failure to do so may compromise the
integrity of this product, your
automobile, and possibly void the
product warranty.
Use this Subwoofer Box with an external
Monoblock subwoofer amplifier that
can handle 1 ohm load impedance and a
maximum of 900W RMS continuous
power, otherwise the amplifier or the
Subwoofer can get damaged.
In case that you need to install an
amplifier please refer to the amplifier’s
instruction manual to perform the
installation of the amplifier before the
use this Subwoofer Box.
Do Not Connect this directly to the
factory radio or aftermarket radio
speaker output. This will not be enough
power for the subwoofers and could be
bad for the radio’s amplifier if is not 1
ohm stable.
Secure the subwoofer box with a strap
or bracket to screw it down in case this
box is loose on your trunk or a SUV
cargo area to avoid this moving around
which will damage the Subwoofer or box
itself. In case of accelerating or hard
braking this will reduce the possibility of
movement! Major injuries may occur in
case of an accident if this is not secured
properly.
If you already have installed
the amplifier then follow these
simple steps:
1 Connect the subwoofer box to the
amplifier using a minimum 12Ga
speaker wire and make sure the polarity
(+) and (-) is correct, otherwise the
sound will be affected.
2 You are now ready to play it for the
first time. It is best to leave the gain all
the
way down in the beginning. Start with a
low volume and work your way up.
3 Now you can tune the amp. We
recommend using the Low Pass Filter at
120Hz or lower depending on your
system. Take your time and make only
one adjustment at a time. It may take
some time to get the system fully
adjusted. During this time the amp is
drawing current from the battery. You
should check the battery voltage from
time to time and re-charge it if it gets
low. That’s it! You are done.
Now have fun!!
INSTALLATION INSTRUCTIONS
FOR MORE INFORMATION
PLEASE VISIT
DS18.COM
We LIKE IT LOUD
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts Owner's manual

Category
Car subwoofers
Type
Owner's manual

DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts is a high-powered subwoofer that is perfect for adding bass to your car audio system. With a peak power handling of 1800 watts, this subwoofer can produce deep, powerful bass that will fill your car with sound. The ported box design helps to extend the bass response, giving you even more low end.

This subwoofer is also very easy to install. It comes with all the necessary hardware, and the instructions are clear and concise. You can have this subwoofer up and running in no time.

Here are some of the key features of the DS18 GEN-X212LD 1*12″ SUBWOOFER IN A PORTED BOX 1800 Watts:

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI