TCP Smart AP Mode Instructions
Lighting
On the home screen press the blue ADD
DEVICE icon (+). Select the LIGHTING group
from the menu and the type of lighting you
want to set up.
Now that your light is flashing quickly the
light needs to be put into AP Mode. Do this
by turning the bulb off & back on again 3
times ( OFF-ON, OFF-ON, OFF-ON ).
The lights should now be flashing slowly.
Click NEXT.
Choose your WiFi network, enter your
password & click NEXT.
Click the GO CONNECT button to connect
directly to your light. Choose SMART LIFE
from the list of available networks.
Once selected return to the TCP Smart App.
Click EZ MODE & select AP MODE from the
menu & click next.
If not already fitted you should fit your light
now. Once fitted your light should start to
flash quickly, click next.
If the bulb does not flash quickly, turn it off
for 10 seconds, then turn it back on & off 3
times. ( ON-OFF, ON-OFF, ON-OFF, ON ).
Wait a few moments for your light to be
added.
Your lights are now connected. You can
rename & choose a room in which they are
fitted.
To finish click DONE. Your lights can now be
used within the TCP Smart App.
www.tcpsmart.euTCP Smart AP Mode Instructions Lighting
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Amcrest IP8M-DT3949EW-3AI User manual
-
Nikon D6 Reference guide
-
-
Secura Key SK-NET Operating instructions
-
Lorex 4KHDIP1612W User manual
-
Lutron Electronics CASETA WIRELESS ELK-M1XSLC Instructions Manual
-
Nikon Z 9 Reference guide
-
Nikon Z f Reference guide
-
Lorex N4K3-1612BB User manual
-
