Omega RT400 Series Owner's manual

Type
Owner's manual

Omega RT400 Series

Below you will find brief product information for Omega RT400 Series.

The Omega RT400 Series Telemetry System is a wireless telemetry system that enables remote data acquisition from sensors without hard-wiring. The system consists of a transmitter (RT400T) and a receiver (RT400R) that communicate via radio frequency (RF) signals.

The RT400T transmitter interfaces with any resistor or strain gauge based sensor and converts the sampled analogue measurements to digital code. This code is sent to the RT400R receiver unit by radio, where the original analogue signal is reconstructed and a scaled output signal is produced.

Omega RT400 Series

Below you will find brief product information for Omega RT400 Series.

The Omega RT400 Series Telemetry System is a wireless telemetry system that enables remote data acquisition from sensors without hard-wiring. The system consists of a transmitter (RT400T) and a receiver (RT400R) that communicate via radio frequency (RF) signals.

The RT400T transmitter interfaces with any resistor or strain gauge based sensor and converts the sampled analogue measurements to digital code. This code is sent to the RT400R receiver unit by radio, where the original analogue signal is reconstructed and a scaled output signal is produced.

  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

Omega RT400 Series Owner's manual

Type
Owner's manual

Omega RT400 Series

Below you will find brief product information for Omega RT400 Series.

The Omega RT400 Series Telemetry System is a wireless telemetry system that enables remote data acquisition from sensors without hard-wiring. The system consists of a transmitter (RT400T) and a receiver (RT400R) that communicate via radio frequency (RF) signals.

The RT400T transmitter interfaces with any resistor or strain gauge based sensor and converts the sampled analogue measurements to digital code. This code is sent to the RT400R receiver unit by radio, where the original analogue signal is reconstructed and a scaled output signal is produced.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI