8804-000035 12/10/03
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: [email protected]
INSTALLATION INSTRUCTIONS
FSB-4201
PANASONIC TC-22LT1 INTERFACE BRACKET
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(1) Interface Bracket (2) M4-.7 X 16mm Phillips Screws, Pan Head
(2) Nylon Spacers, ½(#10) X 3/8” (2) M4-.7 X 10mm Phillips Screws, Pan Head
(1) 1/8” Hex Key (4) M4-.7 X 6mm Phillips Screws, Pan Head
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
LCD DISPLAYS ARE EXTREMELY FRAGILE.
1. Remove screws securing stand to display and remove stand.
2. Using four slotted holes of interface bracket (see Figure 2), align interface bracket with four mounting
holes in the back, outer corners of the display.
3.
Place Nylon spacers between display and interface bracket at top two mounting locations.
4. Using two M4-.7 X 16mm Phillips Screws (provided) at the upper mounting holes, secure bracket
and Nylon spacers to display. Do not over tighten screws.
5. Using two M4-.7 X 10mm Phillips Screws (provided) at the lower mounting holes, secure bracket to
display. Do not over tighten screws.
Optional VESA Mounting
6. Using 1/8” hex key, remove (4) mounting buttons from adapter bracket.
7. Using four inside holes of interface bracket and
M4-.7 X 6mm Phillips Screws (provided)
, secure
interface bracket to any 75mm VESA pattern.
CAUTION!
Figure 1
Figure 2
N
ylon Spacers
M4
-
.7 X 16mm
M4-.7 X 10mm
Optional
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI