1
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Your Hokkaido Furniture is engineered for easy assembly. Carefully follow
this procedure to prevent any damage.
NOTE: This instruction sheet is intended for the entire Hokkaido Table
collection; model 2300 is shown for illustration.
Placement and Maintenance
Hokkaido Furniture is designed for indoor use on level floors. Clean glass
with glass cleaner, and steel parts and wood veneer with a moist cloth.
Step 1
Unpack and identify the parts listed. The assembly workspace should be a
non-marring surface such as carpet. For missing hardware pieces please
contact BDI Customer Service at [email protected]. For all
other concerns, please contact your BDI Retailer.
Component List
Designed by Matthew Weatherly.
‘Hokkaido’ is a trademark of Becker Designed, Inc.
All rights reserved. ©2008 Becker Designed, Inc.
Made in China. 23002301230223102323REV102209v2
H o k k a i d o
2300, 2301, 2302,
2310, 2323
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
2300
2301
2302
2310
2323
D - Long Metal Leg x 4
C - Short Metal Leg x 4
B - Wood Panel x 1
A - Glass Panel x 1
D
C
B
A
Glass Puck
Step 2
Lay Glass Panel (A
) so that the pucks are facing up.
Step 3
Install Short Metal Leg (C) to glass puck.
Step 4
Lay Wood Panel (B)
onto previously installed upper legs. NOTE: Finished wood side facing downward.
Step 5
Install
Long Metal Leg (D) through wood panel hole and into the threaded hole of Short Metal Leg (C).
Step 6
Flip assembled unit over onto base leg position.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI