GA-MG400 Graphics Accelerator
2-3
2.3. HARDWARE INSTALLATION
I. General Installation
1. Shut down the computer.
2. Unplug monitor cable from your computer.
3. Remove your computer’ s unit cover, and ground yourself.
4.
M
Remove the screw and slot bracket from the board’ s mounting.
Be sure removing the existing graphics card from your system, if you
have another graphics card in your system.
5. Pick up the GA-MG400 and remove the plastic sleeve.
6.
M
Press the card firmly into the AGP slot.
Be sure the metal contacts on the card are indeed seated in the slot.
7. Replace the screw to secure the slot bracket of the GA-MG400.
8. Replace your computer’ s unit cover.
9.
Plug your monitor’ s 15-pin connector into your GA-MG400 monitor
connector.
10. Turn on the power.
11. You can install the driver and utility to your system now.
II. Upgrade Installation
1.
Update the motherboard BIOS by the following steps.
a. Use the existing VGA Card to boot.
b. Start the computer into MS-DOS mode or command prompt.
c. Use the BIOS flash utility in the support CD.
d. Follow the system guidance to flash the motherboard BIOS (P3-17).
M Be sure to use the related Motherboard BIOS, flash a wrong BIOS may
cause a damage to the motherboard.
e. Once the process is finished, shut down the system
2.
Remove the existing VGA Card and plug GA-MG400 into the AGP slot.
3.
Turn on the power and install the driver and utility to the system now.