ALGE-Timing Comet User guide

Hello, I'm a chat assistant. I have read the user manual for the ALGE COMET Memo-HP and Memotimer timing devices. The document details the start number input procedure and the RS 232 interface output differences for both models. I'm ready to answer your questions about these devices.
What is the main difference between Memo-HP and Memotimer?

Do I need to confirm the stop impulse on Memo-HP?

How long does the display show the start number before changing to the running time?

When is data sent through the RS 232 interface on Memo-HP?

COMET - Memo-HP Page 1

Version E-92-12-01 Page 1

The program Memo-HP is almost identical with the program Memotimer. The only difference between

Memotimer was made for the start number input in the program „STOP“ as well as for the output through

the RS 232 interface. Please use the manual for Memotimer for further information.

Startnumber Input:

For the program Memo-HP you have to input the start number and confirm it. If you receive a stop impulse

you have not to confirm it again. The display will show the start number and time for three seconds before

it changes to the running time.

You can also input a new start number when the display shows still the previous time. As soon as you

make an input the display will show the running time.

RS 232 Interface:

For Memo-HP it outputs the times different than for the Memotimer. All data will be sent immediately

after a stop impulse. In the program Memotimer it will not send the data until you confirm it.