Hydro-Tek Gear Pump to Motor Conversion Instructions
1) Unscrew the four clamping
bolts
2) Remove the pump flange
(Use a rubberized hammer.
Do not insert any object
between the flange and body
of the pump)
1) Remove the snap ring and
shaft seal from the front of the
pump flange
1) Install the backup washer into
the groove side of the shaft
seal from the conversion kit
1) Install the backup
washer and shaft seal
assembly into the front
of the pump flange
1) Reinstall the snap ring
into the front of the
pump flange
1) Replace the pump flange
2) Retighten the four bolts to a
torque rating of between 52-
54 ft. lbs.
The installation is now
complete
*Note: The converted motor is only unidirectional and will be CCW rotation. If you need
clockwise rotation please use the pump reversing instructions to change the pump rotation
first.