998000060
12-12-19 (REV:02)
BM803300H-DISP ASSEMBLY GUIDE
WARNING: This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product.
1. Install the axle through the hole in the center of the wheel, then slide
a washer on the axle. Insert the axle through the mounting hole in the
pressure washer as shown, then install hitch pin to secure.
3. Rotate the handle 180° to the operating position and reinstall. Reinstall
the bolts and lock nuts and tighten securely using 10 mm and
13 mm wrenches. Torque to 50 in-lbs.
5. Assemble the trigger handle and spray wand.
2. Using 10 mm and 13 mm wrenches, remove the lock nuts and bolts
securing the handle in the shipping position. Lift the handle to remove
4. Align the holes in the storage panel with the holes in the handle as
shown. Install screws and tighten securely using Phillips screwdriver.
6. Place the trigger handle into the holder
and secure using the zip tie as
shown. Trim off the
excess and discard.
/