17 / EN Washing Machine / User’s Manual
The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be
replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until
a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be
the same colour as that visible on the pin face of the plug. Fuse covers are available from
any good electrical store.
Important
Fitting a different plug
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals on your plug, proceed as follows:
1 Connect the green - yellow or green (earth) wire to the
terminal in the plug marked ‘E’ or with the symbol f or
coloured green and yellow or green.
2 Connect the blue (neutral) wire to the terminal in the
plug marked ‘N’ or coloured black.
3 Connect the brown (live) wire to the terminal in the plug
marked ‘L’ or coloured red.
With the alternative plugs a 13A fuse must be fitted either
in the plug or adaptor or in the main fuse box. If in doubt
contact a qualified electrician.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply connections.
3. Drain all water that has remained in the product.
4. Install transportation safety bolts in the reverse order of removal procedure.
CNever move the product without the transportation safety bolts properly fixed in place!
AWARNING: Packaging materials are dangerous to children. Keep packaging materials in a safe
place away from reach of the children.
4.4.8 Initial use
Before starting to use the product make sure that the
preparations are made which are in line with the “Important
Safety and Environment Instructions” and the instructions in
the “Installation” section.
To prepare the product for washing laundry, perform first
operation in Drum Cleaning programme. If this is not
available in your machine, apply the method which is
described in the section 4.7.2.
CUse an anti-limescale suitable for the washing machines.
Some water might have remained in the product due to the quality control processes in the production.
It is not harmful for the product.