28mm Tomb World Barricades
B28-SF-239
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Note: You may find it easier to paint the components for this model before you assemble it.
Take the solid wall sections and base (shown above)
from the sprue.
Glue the walls sections back-to-back and attach
them to the base.
Take the outer wall pieces.
Glue them into position on each side of the wall.
The finished model.
Painting
Note: You may find it easier to paint the components of this model before you assemble it as that will allow you to
access some of the inner details more easily.
We sprayed our model with a black car undercoat aerosol prime. and after that was dry we painted all the wall sections
with a dark green colour before picking out all the detail lines with a bright green.
We used the same bright green to highlight the edges.
The base was dry brushed with a pale grey.
/
