Lytespan
®
Accent Lighting System 8605WH
Page 1 of 1 LyteJacks Point Power Jack Mounts From Above Ceiling
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lightolier a Genlyte Thomas Company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division) • A0902
Features
1. Plug Housing: Aluminum die-casting, contains all electrical components
and supports LyteJack fixture.
2. Plug Jack: Molded high heat resistant thermoplastic.
3. Molded Cap: Flame-retardant ABS; snaps onto flange of Plug Housing.
4. 1/2-14 NPSM Thread (Inside)
5. 90° Electrical Connector
6. Mounting Bars: see accessory table.
7. T-Bar Accessory: Mounts Point Power Jack to ceiling runner.
Recommended for soft ceilings.
8. 16 Ga. Wire: Rated 90°C. 8’ supplied. 8’ maximum distance from Lightolier
transformer to prevent excessive voltage drop.
9. 3/4-14 Nut: Clamps Point Power Jack to ceiling.
10.2 1/4” Dia Washer
11.3/4-14 NPSM Thread: (outside)
12.Center Bushing: Remove for Lytedrops.
Electrical
Use with either Lightolier remote transformer 8608 (75W) or 8609 (225W).
Provided with 8’ of wire (to prevent excessive voltage drop).
Options & Accessory
1950–18” Mounting Bars (set of 2).
1951–27” Mounting Bars (set of 2).
1956–T-Bar Mounting Clips (set of 4).
Labels
UL; I.B.E.W.
Patents
Products shown here are protected by applicable patents and patents
pending.
Catalog No. Finishes Mounting
8605WH Matte White To structurally sturdy ceilings 1/8” to 1 1/2” thick. Must have access from above ceiling.
8618 Matte White T-Bar Accessory mounts 8605WH to ceiling runner. Must have access from above ceiling.
8605WH
8618
Point Power Jack Accessory
/