www.eurolite.de
3
OPERATING DETERMINATIONS
The AKKU PST-3W is a battery-powered pinspot for illuminating objects with
a narrow light cone of 5°. As a light source, a super bright, white 3 W LED is
used. The spot is ideal for mobile use thanks to a quick setup and
rechargeable li-ion battery pack which offers up to 6 hours operating time.
It
easily attaches to metal surfaces with its magnetic base or to drop ceilings
with its scissor clip. The IR remote control IR-7 (accessory) allows convenient
on/off and brightness control of the pinspot. 5 color foils are included for
special effects (warm white, red, green, blue, and yellow).
The device can be operated with the integrated rechargeable battery (7.4 V,
2200 mAh) which can be charged with the included charger. The charger is
allowed to be operated with 230 V, 50 Hz alternating current. The IR remote
control operates with a CR2025 button cell. The devices were designed for
indoor use only.
The F symbol means: This device can be installed on normal inflammable
surfaces. The symbol determines the minimum distance from
lighted objects. The minimum distance between light output and the
illuminated surface must be more than the given value. The maximum
ambient temperature T
a
must never be exceeded. Danger of fire! Make sure
there are no highly flammable materials within a distance of 0.5 m. The
device has to be installed out of the reach of people. The device should be
installed outside areas where persons may walk by or be seated.
For overhead rigging in public or industrial areas, a series of safety
instructions have to be followed that this manual can only give in part. The
operator must therefore inform himself on the current safety instructions and
consider them. The manufacturer cannot be made liable for damages caused
by incorrect installations or insufficient safety precautions!
Do not shake the device. Avoid brute force when installing or operating the
device. When choosing the installation spot, please make sure that the device
is not exposed to extreme heat, moisture or dust. This device must never be
operated or stockpiled in surroundings where splash water, rain, moisture or
fog may harm the device. Moisture or very high humidity can reduce the
insulation and lead to mortal electrical shocks.
The ambient temperature must always be between -5° C and +45° C. Keep
away from direct insulation (particularly in cars) and heaters. The relative
humidity must not exceed 50 % with an ambient temperature of 45° C.
---m