General Safety Information
WARNING
To avoid serious injuries:
● If it is necessary to adjust the length of the chain due to a
change in the number of sprocket teeth, make the cut at
some other place than the place where the chain has been
joined using a QUICK-LINK. The chain cutter will be
damaged if it is cut at a place where it has been joined with a
QUICK-LINK.
If an already-used QUICK-LINK is used again, the chain may
break and serious injury due to accidents may result.
● Use neutral detergent to clean the chain. Do not use alkali-
based or acid based detergent such as rust cleaners as it
may result in damage and/or failure of the chain.
● Check that the tension of the chain is correct and that the
chain is not damaged. If the tension is too weak or the chain is
damaged, the chain should be replaced. If this is not done, the
chain may break and cause serious injury.
● Obtain and read the service instructions carefully prior to
installing the parts. Loose, worn, or damaged parts may
cause serious injury to the rider.
We strongly recommend only using genuine Shimano
replacement parts.
● Read these Technical Service Instructions carefully, and keep
them in a safe place for later reference.
NOTE:
● If the chain keeps coming off the sprockets during use, replace
the sprockets and the chain.
● Parts are not guaranteed against natural wear or deterioration
resulting from normal use.
SI-0047A-001
CN-NX01
Chain
Technical Service Instructions
Installation of the chain
1.
Remove the outer link at the connection
location so that both ends of the chain
fi nish at an inner link.
2.
Insert the connecting link with pins
section of the QUICK-LINK as
shown in the illustration.
Inner link Inner link
Inner link Inner link
Connecting link with pins
3.
Place the connecting link with hole onto one of the pins, and then slide
the connecting link so that the pin is at the other end from the hole.
(The side of the link plate with the depression should be facing toward
the outside at this time.)
Hole
Depression should
be on the outside
Connecting link with hole
4.
Turn the connecting link with hole until it overlaps the other pin.
Hole
5.
Loosen the chain and insert the pin securely into the hole.
2
1
Insert the pins into the
hole while pushing the
connecting link with hole.
There should be no gap between the
connecting link with pins and the
inner link.
Inner link
Connecting link with pins
6.
Set both pins securely into the slot of the connecting link with hole, and
check that both plates are parallel.
Parallel
* Service Instructions in further languages are available at :
http://techdocs.shimano.com
Please note: Specifi cations are subject to change for improvement without notice. (English)
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222
3-77 Oimatsu-cho, Sakai, Osaka 590-8577, Japan
Jun. 2009 by Shimano Inc. AWS. IZM. Printed in Taiwan
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Shimano RD-M971 Service Instructions
-
Shimano SL-M970 Service Instructions
-
Shimano ST-M970 Service Instructions
-
-
Shimano ST-M775 Service Instructions
-
Shimano SL-M980 Service Instructions
-
-
Shimano SL-M660 Service Instructions
-
Shimano SL-M780-I Service Instructions
-
Shimano ST-T300-S Service Instructions