Generation Lighting 39806BLE-962 Installation guide

Category
Floodlights
Type
Installation guide

This manual is also suitable for

1A
Install the Fixture
Use 120 voltMAX 75 Watt
Type A19 Medium Base Lamp.
NOTE: This fixture may be used as a down
or up light by simply rotating the fixture arms.
The up light version is shown.
ELECTRICAL BOX
MOUNTING PLATE
MOUNTING PLATE SCREW
CANOPY
THREADED NIPPLE
SCREW COLLAR
COLLAR NUT
LAMP
SHADE
SHADE BASE
SOCKET
2
6
1
12
CHAIN
3
2
Screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the electrical box with two mounting plate screws.
Temporarily unscrew and remove the collar nut and screw the screw collar tightly onto the threaded nipple.
Screw the long threaded nipple onto the fixture, place the nipple cover and the lower canopy onto the long threaded
nipple. Finally place the fixture loop washer on the long threaded nipple and screw the fixture loop on tightly.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it
from the bottom.
Install the canopy and the collar nut onto the chain (in that order) then install the open link onto the fixture loop and
secure it in place by closing the link.
Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the electrical box. Trim the cord
leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and rigid tracer) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and smooth tracer) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing
the collar nut tightly onto the screw collar.
Place the shade onto the shade base and secure them in place by installing and tightly screwing the shade collar nut
onto the socket; repeat for all shades.
Install the lamp by pushing the lamp pins into the large portion of the socket slots and rotate it clockwise to lock it in
place.
1
2
3
4
5
6
7
8
9
10
11
12
13
SHADE COLLAR NUT
LOWER CANOPY
LONG THREADED NIPPLE
NIPPLE COVER
4
4
4
4
6
13
Use type spiralMAX 13 Watt
self-ballasted, GU24 base
compact fluorescent lamp.
FIXTURE LOOP
FIXTURE LOOP WASHER
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Generation Lighting 39806BLE-962 Installation guide

Category
Floodlights
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI