Progress PC3205 User manual

Category
Vacuum cleaners
Type
User manual
English
P
P
R
R
O
O
G
G
R
R
E
E
S
S
S
S
P
P
C
C
3
3
2
2
0
0
0
0
,
,
P
P
C
C
3
3
2
2
0
0
1
1
,
,
P
P
C
C
3
3
2
2
0
0
5
5
– 1 –
IMPORTANT SAFEGUARDS
Ø
Read this instruction booklet carefully.
Ø
Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the
rating plate.
Ø
Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug. Do not try to repair the appliance by yourself. For
repairs or accessories, contact Electrolux
Customer Services on 08706 055 055.
Ø
Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.
Ø
Never leave the appliance unattended when it is switched on. Keep the appliance out of reach of children.
Ø
This appliance is for domestic use only. Use as described in this instruction booklet.
Ø
Do not pull the appliance by the cord. Do not unplug by pulling on the cord.
Ø
Do not use appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts. Do not
vacuum up any highly flammable or explosive substances or gases.
Ø
Do not unplug the vacuum cleaner with wet hands.
Ø
Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc.
Ø
Before you start using the vacuum cleaner, please remove large or sharp objects from the floor to prevent damage to the cloth dustbag.
INSTRUCTIONS FOR USE
Ø
Before placing into operation make certain that the filters are in the proper position.
Ø
Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the power cable shows
the ideal cable length. Do not extend the cable beyond the RED mark.
Ø
Press the ON/OFF button to switch the appliance on. It is advisable to set the power control to MIN before switching on the appliance (PC3201,
PC3205).
Ø
To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing damage.
Ø
By moving the variable power control, the suction power can be adjusted (PC3201, PC3205).
DESCRIPTION
1. Suction inlet
2. Dustbag full indicator
3. Variable power control (PC3201, PC3205)
4. On/off switch
5. Cable rewind button
6. Wheel
7. Dustbag compartment
8. Carrying handle
9. Compartment open button
10. Hose
11. Metal tubes (PC3200, PC3205)
12. Telescopic tube (PC3201)
13. Floor nozzle (PC3200)
14. Dual purpose floor nozzle (PC3201, PC3205)
15. Upholstery nozzle (PC3201, PC3205)
16. Crevice nozzle (PC3201, PC3205)
17. Dustbag
18. Clothbag (PC3200, PC3201)
19. Vertical parking
20. Horizontal parking
(PC3201,
PC3205)
(PC3201,
PC3205)
(PC3201)
(PC3200, PC3205)
(PC3200)
(PC3201, PC3205)
(PC3201, PC3205)
15. 16.
12.
11.
17.
18.
14.
13.
19. 20.
(PC3200,
PC3201)
10.
31.30.29.
28.
27.
26.25.24.
21. 22. 23.
PC32xx_ifu_press.qxp 2005.05.09. 17:45 Page 5
P
P
R
R
O
O
G
G
R
R
E
E
S
S
S
S
P
P
C
C
3
3
2
2
0
0
0
0
,
,
P
P
C
C
3
3
2
2
0
0
1
1
,
,
P
P
C
C
3
3
2
2
0
0
5
5
– 25 –
MAINTENANCE
REPLACING THE DUSTBAG
Menalux branded Dustbags and Filters are strongly recommended by Progress. Those high quality bags and filters will ensure a
long lifetime of your Progress vacuum cleaner.
For more information about Menalux products, please visit our website: www.menalux.com.
Ø
Always operate the cleaner with the dustbag installed.
Ø
If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely.
Ø
After removing the flexible hose, open the front cover (fig. 21).
Ø
Remove the support of the bag.
Ø
Remove the dustbag and insert a new one (fig. 22).
Ø
Close the cover by pressing down until it clicks (fig. 21).
RECOMMENDED DUST BAG: Menalux T183 is the approved dustbag for your Progress vacuum cleaner.
TROUBLE FINDING YOUR MENALUX DUST BAG?
If you do not find Menalux at your store, please call:
UK: 8 706 055 055
IRL: 14 09 07 50
Textile dustbag (PC3200, PC3201)
Ø
Remove the textile bag from the holder (fig. 23).
Ø
Slide the plastic clip away from the bag to open and empty it (fig. 23-24).
Ø
Replace the plastic clip ensuring that both sides of the bag are parallel (fig. 23).
Ø
Replace the bag into the holder (fig. 23).
Note: The bag may be washed in luke warm water and dried completely. It should not be washed in washing machine (fig. 26).
Ø
Close the cover by pressing down until it clicks (fig. 21).
REPLACING THE FILTERS
Ø
The dustbag must be replaced if the window of the dustbag full indicator is completely red when the cleaner is operating at maximum power and the
nozzle is raised from the floor.
Ø
Filters should be replaced at least twice a year or when they become visibly soiled.
Ø
Always operate the cleaner with filters installed to avoid reduced suction.
Ø
Disconnect from electrical outlet before changing the filters.
Ø
Do not use a washing machine to rinse filters.
Ø
Pull dustbag upward and remove the motor protection filter (fig. 27).
Ø
Rinse the filter under tap water and dry it completely (fig. 28).
Ø
Place the filter back into the cleaner (fig. 27).
Ø
Open the filter cover to remove the exhaust filter with grill (fig. 29, 30).
Ø
Take the filter out of the grill (fig. 31).
Ø
Rinse the filter under tap water and dry it completely (fig. 28).
Ø
Place the filter back into the grill and put it back into the cleaner (fig. 30, 31).
Ø
Close the filter cover (fig. 29).
RECOMMENDED FILTERS:
- Menalux Micro Filter: D09.
- Menalux Motor Filter: D24.
PROTECTING THE ENVIRONMENT
Ø
Attempt to recycle packaging material and old appliances.
Ø
The cardboard packaging can be placed in the waste paper collection.
Ø
Deposit the plastic bag made of polyethylene (PE) at the PE collection point for recycling.
Recycling the Appliance at the end of its life:
Ø
The plastic components all carry a material identification marking so that, like the other materials, they can be recycled at the end of the life of the appli
-
ance.
Ø
Please inquire with your local authority.
Blocked air flow and dirty filters:
Ø
The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt.
Ø
Disconnect from mains and allow the cleaner to cool for 20-30 minutes. Remove blockage and/or clean filters.
Ø
Restart the cleaner
.
– 2 –
3302 02 03 03
PC32xx_ifu_press.qxp 2005.05.09. 17:46 Page 9
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

Progress PC3205 User manual

Category
Vacuum cleaners
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI