Before using for the first time en
53
Note: When selecting "yes", please
read the detailed description in the
section "Home Connect".
Do you want to insert a water filter?
â– If you want to insert a water filter
now, confirm "yes" with the
right-hand navigation button.
â– To insert a water filter later, select
"no" with the left-hand navigation
button.
Note: If selecting "yes", please read the
detailed description in the section
"Starting the "Water filter" or "Frost
protection" programme" from the item
"Inserting or replacing a water filter".
The reminder "Fill bean container" lights
up briefly.
Either confirm with the right-hand
navigation button or wait a few seconds.
The reminder "Please fill water tank"
lights up. Fill the water tank.
Filling the bean container
This appliance can be used to prepare
coffee drinks from coffee beans or
ground coffee (not instant coffee).
1. Open the lid )R of the bean
container )B.
2. Add beans.
3. Close the lid again.
Notes
â– Coffee beans that have been glazed
or caramelised or treated with other
sugary additives will block the
brewing unit. Only use pure bean
mixes that are suitable for use in fully
automatic coffee or espresso
machines.
â– Never use unroasted coffee beans.
â– The coffee beans are freshly ground
for each brewing operation.
â– Store coffee beans in a sealed
container in a cool place to ensure
optimum quality.
â– Coffee beans can be kept in the
bean container for a number of days
without losing their aroma.Only ever
add the ground coffee shortly before
beverage preparation. ~ "Preparing
coffee using ground coffee"
on page 56
In models with two bean containers )B
, )b* you can pour in two different
types of coffee beans. Select the
desired bean container using the
selection button 1"*. The LED of the
active bean container lights up.
The appliance memorises the most
recently used bean container for each
drink. This presetting can be modified.
~ "Menu settings" on page 64
Filling the water tank
Important: Fill the water tank with fresh,
cold, still water on a daily basis. Prior to
operation, check whether the water tank
has been sufficiently filled.
1. Hold the recessed grip )" on the
side of the water tank ` and
gently tilt out the water tank to the
side.
2. Use the handle to remove the water
tank and then rinse out.
3. Fill the water tank with water up to
the "max" marking.
4. Re-insert the water tank in the holder
and tilt back to the starting position.
The brand logo lights up on the display.
The appliance heats up and rinses.
Some water will run out of the outlet
system.
The appliance is ready for use when the
symbols for the beverages and the
on/off button light up on the display.