CLEANING THE COMBINATION BRUSH (4)
With the motor ON, rub the brush with your hand to remove the dust and fluff, which will be
drawn.
CLEANING THE DUST COLLECTION SYSTEM (15)
When the suction power of the vacuum cleaner decreases or the clogged filter LED (20)
turns red, remove the dust from the appliance.
ATTENTION! Empty the dust compartment (15) and clean the filters (15D-
15E) after every use.
If the suction power of the vacuum cleaner does not improve after cleaning the dust
collection system, the Hepa filter and the sponge filter of the vacuum cleaner could be very
dirty. In this case, replace them.
If replacing the Hepa filter (15D), it is recommended to also replace the other filtering
elements.
Clean the dust collection system following the instructions below and paying attention to the
figures in the illustrative guide.
CLEANING THE DUST CONTAINER (15)
Press the release button (11) to extract the dust container (15A) from the appliance
[Fig. G1].
the container [Fig. G2].
CLEANING THE HEPA FILTER (15D) AND THE SPONGE FILTER (15E)
Remove the dust collection system (15) from the appliance [Fig. G1].
Remove the Hepa filter (15D) from the dust collection system (15) [Fig. G3].
Remove the sponge filter (15E).
If the Hepa filter (15D) and the sponge filter (15E) are clogged with dust, wash them
Refit the Hepa filter (15D) and the sponge filter (15E) on the dust collection system (15).
Insert the dust collection system (15).
Insert the dust collection system before restarting the appliance.
CLEANING THE OUTLET FILTER (16)
not to damage it and let it dry completely.
Refit the outlet filter (16) in the appliance [Fig. G4].
ATTENTION!
Let the filters dry for at least 24 hours after washing them. Do not reinstall
the filter if it is damp!
REPLACING THE HEPA FILTER (15D)
Remove the dust collection system from the appliance [Fig. G1].
Remove the Hepa filter (15D) from the support and replace it with a new filtering insert
[Fig. G3].
Refit the appliance and insert the dust collection system before restarting it.
EN
14