14
iten
PART
1. Fixing clamp
2. Skirt
3. Protective cap
4. Maximum water level
5. Minimum water level
6. Actual temperature display
7. Start/stop Key
8. Temperature Icon
9. Time Icon
10. + and - buttons
11. Temperature/time key
12. Setting displays
INTRODUCTION
HOW TO USE THE EASY CHEF
Read the following instructions carefully to get
maximum use of your Easy Chef:
1. Attach the appliance to a pot. It should clip on
the far side of the pot and face toward you. We
recommend using a pot that is at least 18 cm
tall. Note to not put the pot over a temperature-
sensible surface.
2. Add water to the pot. The water level must be
between the “Min” and “Max” levels on the ap-
pliance, consider that the water level will rise
when you add food to the container.
3. Connect the appliance to the power source, one
beep will be heard, all the indicators will illumina-
indicator will light in red.
4. Press key once, its indicator will blink in red
and the will light on, and the “Setting tempe-
rature/time display” will show the default tempe-
-
red temperature by “+” and “-” keys, in a range
or “- ” keys to increase or decrease the tempe-
rature quickly.
5. , key,
the lights on and the “Setting temperature/
time display” will show the default time “1:30”
range between zero (00:00) and 99 hours and
50 minutes (99:50), by “+” and “-” keys. Hold and
press the “+” or “-” keys to increase or decrease
the time quickly.
6. key once, it
will illuminate in white, the appliance will start to
heat basing on the above settings. the “Actual
temperature display” will show the actual water
temperature in Celsius degrees.
NOTA: During heating process, you can press key
to check the setting temperature and time. You can
also reset the temperature and time when the setting
temperature is not reached. The operation for reset-
3 seconds otherwise the appliance will operate based
on current setting.
NOTA:
During working, you can hold and press “ ”
key
for about 2 seconds to pause and enter into standby
mode.
7. Wait for the water to heat up to the setting tem-
perature. One beep can be heard when the set-
ting temperature is reached. Press key once
to start the product and let the time count down.
NOTA: The appliance will enter into standby condi-
tion if no any operation within 30 minutes after the
setting temperature is reached.
8. Add your food in the pot and let the appliance
operate. Three beeps can be heard when the
enter into standby mode.
NOTA: The skirt part will become very hot during wor-
king or after working, please do not touch it unless it is
cooled down completely.
9. Unplug the appliance and clean it by following
the operation of “CLEANING” before storing.
CLEANING
Allow the appliance to cool down to ambient
temperature and then wipe it down carefully with a
damp cloth and dry before storing.
If the immersed parts become greasy or need more
cleaning:
1. Put the appliance in a pot as described in “how
2.
3. Add 1/2 tablespoon non-foaming dishwashing
liquid every 4 water liters.
4. Allow the water to circulate for 10 minutes after
5.
6. When the appliance is cool, rinse the bottom
with cold water and dry before storage.