Dell 470 Owner's manual

Dell Vostro 470

Owner's Manual

Regulatory Model: D10M

Regulatory Type: D10M002

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use of your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed.

WARNING: A WARNING indicates a potential for property damage, personal injury, or death.

Information in this publication is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell

™

, the DELL logo, Dell Precision

™

, Precision ON

™

,ExpressCharge

™

, Latitude

™

, Latitude ON

™

,

OptiPlex

™

, Vostro

™

, and Wi-Fi Catcher

™

are trademarks of Dell Inc. Intel

®

, Pentium

®

, Xeon

®

, Core

™

, Atom

™

, Centrino

®

, and Celeron

®

are registered trademarks or trademarks of Intel Corporation in the U.S. and other countries. AMD

®

is a registered trademark and

AMD Opteron

™

, AMD Phenom

™

, AMD Sempron

™

, AMD Athlon

™

, ATI Radeon

™

, and ATI FirePro

™

are trademarks of Advanced Micro

Devices, Inc. Microsoft

®

, Windows

®

, MS-DOS

®

, Windows Vista

®

, the Windows Vista start button, and Office Outlook

®

are either

trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. Blu-ray Disc

™

is a trademark

owned by the Blu-ray Disc Association (BDA) and licensed for use on discs and players. The Bluetooth

®

word mark is a registered

trademark and owned by the Bluetooth

®

SIG, Inc. and any use of such mark by Dell Inc. is under license.

Wi-Fi

®

is a registered

trademark of Wireless Ethernet Compatibility Alliance, Inc.

Other trademarks and trade names may be used in this publication to refer to either the entities claiming the marks and names or their

products, Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

2012 – 03

Rev. A00

Contents

Notes, Cautions, and Warnings...................................................................................................2

1 Working on Your Computer.......................................................................................................5

Before Working Inside Your Computer.....................................................................................................................5

Recommended Tools................................................................................................................................................6

Turning Off Your Computer.......................................................................................................................................6

After Working Inside Your Computer........................................................................................................................6

2 Removing The Cover...................................................................................................................7

Installing The Cover..................................................................................................................................................8

3 Removing The Memory..............................................................................................................9

Installing The Memory..............................................................................................................................................9

4 Removing The Expansion Card ..............................................................................................11

Installing The Expansion Card................................................................................................................................12

5 Removing The Optical Disk Drive...........................................................................................13

Installing The Optical Disk Drive.............................................................................................................................14

6 Removing The Hard Disk Drive...............................................................................................15

Installing The Hard Disk Drive................................................................................................................................16

7 Removing The Memory Card Reader.....................................................................................19

Installing The Memory Card Reader.......................................................................................................................20

8 Removing The Rear System Fan.............................................................................................21

Installing The Rear System Fan..............................................................................................................................22

9 Removing The Coin-Cell Battery.............................................................................................23

Installing The Coin-Cell Battery..............................................................................................................................23

10 Removing The Heat Sink........................................................................................................25

Installing The Heat Sink..........................................................................................................................................26

11 Removing The Processor.......................................................................................................27

Installing The Processor.........................................................................................................................................27

12 Removing The Power Supply Unit........................................................................................29

Installing The Power Supply Unit............................................................................................................................32

13 Removing The System Board................................................................................................33

Installing The System Board...................................................................................................................................35

14 Removing The Front Bezel.....................................................................................................37

Installing The Front Bezel.......................................................................................................................................38

15 Removing The WLAN Card....................................................................................................39

Installing The WLAN Card......................................................................................................................................40

16 Removing The Power Switch And The Hard Drive Activity LED.....................................41

Installing The Power Switch And The Hard Drive Activity LED..............................................................................42

17 Removing The Front Audio Module......................................................................................45

Installing The Front Audio Module..........................................................................................................................46

18 Removing The Front USB Module........................................................................................47

Installing The Front USB Module............................................................................................................................47

19 System Setup Overview.........................................................................................................49

Entering System Setup............................................................................................................................................49

System Setup Screens............................................................................................................................................49

System Setup Options.............................................................................................................................................50

Main.................................................................................................................................................................50

Advanced.........................................................................................................................................................51

Security............................................................................................................................................................53

Boot..................................................................................................................................................................53

Exit....................................................................................................................................................................53

20 Diagnostic Error Messages...................................................................................................55

Diagnostic Beep Codes..........................................................................................................................................56

System Messages...................................................................................................................................................56

21 Specifications..........................................................................................................................59

22 Contacting Dell........................................................................................................................63

Contacting Dell.......................................................................................................................................................63

1

Working on Your Computer

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your

personal safety. Unless otherwise noted, each procedure included in this document assumes that the following

conditions exist:

• You have read the safety information that shipped with your computer.

• A component can be replaced or--if purchased separately--installed by performing the removal procedure in

reverse order.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For

additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/

regulatory_compliance.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically

touching an unpainted metal surface, such as a connector on the back of the computer.

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a

card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its

pins.

CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some

cables have connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs

before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any

connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

NOTE: The color of your computer and certain components may appear differently than shown in this document.

To avoid damaging your computer, perform the following steps before you begin working inside the computer.

1. Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.

2. Turn off your computer (see Turning Off Your Computer).

CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable

from the network device.

3. Disconnect all network cables from the computer.

4. Disconnect your computer and all attached devices from their electrical outlets.

5. Press and hold the power button while the computer is unplugged to ground the system board.

6. Remove the cover.

5

CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal

surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal

surface to dissipate static electricity, which could harm internal components.

Recommended Tools

The procedures in this document may require the following tools:

• Small flat-blade screwdriver

• #0 Phillips screwdriver

• #1 Phillips screwdriver

• Small plastic scribe

• Flash BIOS update program CD

Turning Off Your Computer

CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your

computer.

1. Shut down the operating system:

– In Windows Vista :

Click Start , then click the arrow in the lower-right corner of the Start menu as shown below, and then

click Shut Down.

– In Windows XP:

Click Start → Turn Off Computer → Turn Off . The computer turns off after the operating system shutdown

process is complete.

2. Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not

automatically turn off when you shut down your operating system, press and hold the power button for about 4

seconds to turn them off.

After Working Inside Your Computer

After you complete any replacement procedure, ensure you connect any external devices, cards, and cables before

turning on your computer.

1. Replace the cover.

CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the

computer.

2. Connect any telephone or network cables to your computer.

3. Connect your computer and all attached devices to their electrical outlets.

4. Turn on your computer.

5. Verify that the computer works correctly by running the Dell Diagnostics.

6

2

Removing The Cover

1. Follow the procedures in Before working Inside your computer.

2. Remove the two thumbscrews securing the computer cover to the computer.

Figure 1.

3. Slide the computer cover towards the back of the computer, and then remove it from the computer.

Figure 2.

4. Lift the computer cover away from the computer.

7

Figure 3.

Installing The Cover

1. Place the computer cover on the computer and slide it inwards from the back of the computer.

2. Replace and tighten the thumbscrews that secure the computer cover on the computer.

3. Follow the procedures in After Working Inside Your Computer.

8

3

Removing The Memory

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the cover.

3. Press down on the memory retaining tabs on each side of the memory modules and lift the memory module

upwards to remove it from the computer.

Figure 4.

Installing The Memory

1. Align the notch on the memory-card with the tab in the system-board connector.

2. Insert the memory module into the memory socket.

3. Press down on the memory module until the securing clips secure the memory in place.

4. Install the cover.

5. Follow the procedures in After Working Inside Your Computer.

9

10

4

Removing The Expansion Card

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the cover.

3. Press down on the blue retainer tab in an outward direction and push the retention panel downwards.

Figure 5.

4. Press down the latch and pull the expansion card away from the computer.

Figure 6.

11

Installing The Expansion Card

1. Push the expansion card into the card slot and secure the latch.

2. Install the expansion card retainer module to the chassis.

3. Install the cover.

4. Follow the procedures in After Working Inside Your Computer.

12

5

Removing The Optical Disk Drive

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the cover.

3. Disconnect the power cable and the data cable from the back of the optical drive.

Figure 7.

4. Remove the screws that secure the optical drive to the drive cage.

Figure 8.

5. Slide out the optical drive through the front of the computer.

13

Figure 9.

Installing The Optical Disk Drive

1. Slide the optical drive in through the front of the computer.

2. Replace the screws that secure the optical drive to the drive cage.

3. Connect the power cable and data cable to the optical drive.

4. Install the cover.

5. Follow the procedures in After Working Inside Your Computer.

14

6

Removing The Hard Disk Drive

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the cover.

3. Disconnect the power cable and the data cable from the back of the hard drive.

Figure 10.

4. Remove the screws that secure the hard drive cage to the chassis.

Figure 11.

15

5. Slide out the hard drive by lifting it in an upward direction.

Figure 12.

6. Remove the screws that secure the hard drive to the drive cage.

Figure 13.

7. Pry the hard drive cage in the direction indicated to remove the hard drive from the hard drive cage.

Figure 14.

Installing The Hard Disk Drive

1. Tighten the screws that secure the hard drive to the drive cage.

2. Place the hard drive into the slot and tighten the screws that secure the hard drive cage to the chassis.

16

3. Connect the power cable and data cable to the hard drive.

4. Install the cover.

5. Follow the procedures in After Working Inside Your Computer.

17

18

7

Removing The Memory Card Reader

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the cover.

3. Disconnect the memory card cable from the system board.

Figure 15.

4. Unroute the memory card reader cable from the retention clip.

Figure 16.

5. Remove the screws that secure the memory card reader to the drive cage.

19

Figure 17.

6. Slide the multimedia card reader out through the front of the computer.

Figure 18.

Installing The Memory Card Reader

1. Slide the memory card-reader in through the front of the computer.

2. Replace and tighten the screws that secure the multimedia card-reader to the drive cage.

3. Route the memory card reader cable through the retention clip.

4. Connect the memory card reader cable to the system board connector.

5. Install the cover.

6. Follow the procedures in After Working Inside Your Computer.

20

Page is loading ...

Dell 470, Vostro 470 Owner's manual

Related papers

Other documents