2. Enwork
  3. Equilibrium™

Enwork Equilibrium™ Installation guide

  • Hello! I'm a chat assistant and I've read through the ENWORK Equilibrium Work Surface Installation Guide for the E10009 Conference Table. I understand the document provides instructions on how to install the work surface, including how to align the table base and attach the work surface segments using tight joints. I am ready to help you with any questions you might have about this installation process.
  • How many tight joints are on a standard 36"-48"D work surface?
    How many tight joints are on a 54"-72"D work surface?
    What tool is used to tighten the tight joints?
Equilibrium Work Surface Installation Guide – Rev B.
EQUILIBRIUM WORK SURFACE
INSTALLATION GUIDE
CONFERENCE TABLE
EI0009
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
2) TOOLS AND SUPPLIES REQUIRED
Base Assembly
Drill
Work Surface
5⁄32 Hex Bit
Tight Joint
Level
INSTALLATION GUIDE
3) ASSEMBLY: WORK SURFACE INSTALLATION
Before installing the Work Surface, verify that
the table Base is level and that the Support
Beams are parallel. Refer to the Equilibrium
Installation Guide for leveling instructions.
Verify how many Tight-Joints are on the Work
Surface. Standard Work Surfaces 36”- 48”D
have (4) tight joints per seam, and 54” -72”D
tops have (6) tight joints per seam.
Place the Work Surface on the Base,
Tight-Joint channels down.
Loosely install all the Tight-Joints. The
Work Surface may be moved to access
all the Tight-Joint Locations. Do not
completely tighten the Tight-Joints yet.
FIGURE 1
FIGURE 2
FIGURE 3
INSTALLATION GUIDE
3) ASSEMBLY: WORK SURFACE INSTALLATION
CONT. 1
Conrm that each Work Surface segment is
level. For three piece Work Surfaces level the
middle segment rst.
Check the alighnment of each Work Surface. If
necessary, light pressure may be used to alighn
the surfaces. Do not tighten the Tight-Joints
completely, starting from the outermost joints
to the center with the 5⁄32 Hex tool.
This may require two people.
Attach the Work Surface to the table Base. If
the Work Surface has embedded braces, verify
that the screw heads do not interfere with the
table Base. If they interfere with the table Base,
they may be removed as necessary.
Repeat these steps for each table seam.
FIGURE 4
FIGURE 5
FIGURE 6
Specications subject to change without notice.
Rev 02.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/