Recommended NINJA P
installation position
If NINJA P is inserted
completely, use 5 mm
Allen key to remove.
User's Guide
NINJA P GB
STORE NINJA P IN SEATPOST
REMOVE NINJA P FROM SEATPOST
HOW TO CHANGE RUBBER RING
Presta Valve Inflation Head
Put the pump into seatpost and turn Locking
Grip counter-clockwise to seal the Rubber
Ring. (DO NOT insert pump completely into
seatpost.)
Turn Locking Grip clockwise to loosen the
Rubber Ring and remove the pump.
Rubber Ring x 2
(for ø 30.9 / 31.6 mm seatpost)
Dust Cover
2-year Warranty: All mechanical components
against manufacturer defects only.
Warranty Claim Requirements
To obtain warranty service, you must have your
original sales receipt. Items returned without a
sales receipt will assume that the warranty begins
on the date of manufacture. All warranties will be
void if the product is damaged due to user crash,
abuse, system alteration, modification, or used in
any way not intended as described in this manual.
* The specifications and design are subject to
change without notice.
Please contact your Topeak dealer with any
questions. For USA customer service,
call: 1-800-250-3068
www.topeak.com
WARRANTY
Fits ø 27.2, 30.9 & 31.6 mm ROUND SEATPOST only. Please read the User’s Guide before first use.
Rubber Ring (for ø 27.2 mm seatpost)
Locking Grip
Seatpost Position Indicator
(for ø 27.2 mm seatpost)
Included position
indicators keep
track of your
seat height
Seatpost Position Indicator
(for ø 30.9 / 31.6 mm seatpost)
Make sure Ninja P is installed in
seatpost properly during a period
of time.
WARNING
Avoid pinching
fingers while
pumping
CLOSE OPEN
FRONT
REAR
Rubber Ring x 2
(for ø 27.2 mm seatpost)
Rubber Ring x 2
(for ø 30.9 / 31.6 mm
seatpost)
Turn Locking Grip to expand rubber ring
for initial fit.
IMPORTANT NOTE
Copyright © Topeak, Inc. 2015 M-TNJ-P-GB 11/15
/
