DOD Boneshaker Distortion Guitar Effects Pedal Owner's manual

Hello! I've reviewed the user manual for the DOD Boneshaker distortion pedal and I'm ready to answer your questions about it. I can tell you about the controls for distortion, depth, level and EQ, its optimal placement in the effects chain and its capability to work with other distortion pedals.
Where should I place the Boneshaker in my effects chain?

Can the Boneshaker be used with other distortion pedals?

What type of power supply does the Boneshaker use?

1 2 3

4 5 6

1 2 3

4 5 6

1. DISTORTION - adjusts the amount of distortion gain.

2. DEPTH - adjusts the low frequency ‘growl’ of extended range instruments.

3. LEVEL - adjusts the overall output level of the distortion eect.

4. LOW - adjusts the low EQ frequency and its level.

5. MID - adjusts the mid EQ frequency and its level.

6. HIGH - adjusts the high EQ frequency and its level.

7. INPUT - connect your instrument here.

8. FOOTSWITCH - turns the eect on and o.

9. LED - turns on when the eect is enabled.

10. OUTPUT - connect to the next pedal’s input or to the input of your amplier.

USING BONESHAKER:

Most guitarists/bassists will favor placing the Boneshaker at the

beginning of their chain of eects, so start with that placement.

A typical eects signal chain will consist of Distortion eects rst

then Modulation

eects (Chorus, Flanger, Phaser, Tremolo, etc...) next and then

nally Time based eects (Delay and Reverb).

Placing the Boneshaker toward the front of your chain or eects

will preserve vibe no matter the pedal combination that follows.

You may wish to experiment with the eect placement since

Boneshaker also stacks well with other distortions and fuzz!

SPECIFICATIONS:

Input

Output

Current Draw

Bypass

Power

Warranty

1/4” TS Unbalanced - 470 kΩ

1/4” TS Unbalanced - 100 Ω

20 mA

True Bypass

9VDC alkaline battery (not included)

PS200R power adapter (optional)

1 Year

DOD

59 Hwagok-ro 61gil

Gangseo-gu, Seoul 07590

Republic of Korea