Brodit 855028 Datasheet

Category
Holders
Type
Datasheet
29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 855028
855028 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288550282
Item no 855028 fits:
Chrysler 200 15 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of
adhesive tape on the ProClip. Place the ProClip over the area where it is supposed to be attached for proper
alignment
2. Press the angled edge on the lower part of the ProClip into the gap between the two padded dashboard
sections.
3. Flip the ProClip upward so the angled edge on the lower part hooks behind the padded dashboard section.
Then place you index finger underneath the upper part of the ProClip. Pull upward and hook the angled edge
over the air vent edge. Note: to make the angled edge go all the way into the seem between the air vent and the
surrounding panel frame pull towards you and press down at the same time
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 855028 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI