2. Allied Brass
  3. WP-HTL/24-5-ABR
WP-HTL/24-5-ABR

Allied Brass WP-HTL/24-5-ABR Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Allied Brass WP-HTL/24-5-ABR Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
LEFT SIDE ASSEMBLY
RIGHT SIDE ASSEMBLY
LEFT SIDE ASSEMBLY
RIGHT SIDE
ASSEMBLY
Tube
Step 1:
Place the Left and Right side assemblies upright on the floor with short assembly nipples pointing towards each other.
SIDE ASSEMBLY
Step 2:
TUBE ASSEMBLY
Slip each of the 6 long shelf tubes over short Left side assembly nipples, then slide the Right side assembly inward, inserting
the assembly nipples into the other ends of the Long tubes.
WP-HTL-5
ASSEMBLY INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
DRILLED HOLE
SET SCREW
SCREW
ANCHOR
MOUNTING PLATE
BACK PLATE
Step 1:
Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting
plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark
made above. Measure and mark two holes on the wall for each mounting plate based on the center to center locations of the
4 back plate mounting plate . Drill hole at each of the marks. (You maysubstitute other style mounting anchors or screws if
desired). Place anchors into the holes made. Place mounting plate overholes and secure to mounting surface using screws
as shown below.
Drill holes in Wall for screw anchors and attach Mounting Plate to Wall
PERSPECTIVE
DRILLED HOLE
WP-HTL-5
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
L
DETAIL L
SET SCREW
MOUNTING PLATE
Step 2:
Place bracket on mounting plate and secure by tightening set screw as shown below.
Attach Bracket to Mounting Plate.
PERSPECTIVE
BACK PLATE
WP-HTL-5
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
/