STEP 3
STEP 4
READS
“THIS
SIDE
UP”
STEP 2
STEP 1
DO NOT USE:
INSTALLATION INSTRUCTIONS
:DEDEEN SLOOT
1. Separate snap-on insert from bolt cap.
2. Remove nut and washer from bolt located on base of bowl.*
With correct side up, place snap-on insert over thread of bolt.
3. Replace existing washer and nut.
4. Snap on bolt cap.
*To avoid removing nut and washer from floor bolts, fill bolt cap
with caulking or silicon sealant and position over floor bolt.
Follow instructions on caulking package. Discard snap-on
inserts.
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675 U.S.A.
www.xthistoilet.com
®
© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product
instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be
liable for any damages resulting from failure to install or maintain the product in accordance
with the product instructions, from abuse or misuse of the product, from use of
non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl
cleaners containing bleach or chlorine.
/
